Fisher-Price GeoTrax M3234 User manual

www.fisher-price.com
M3234

Battery Installation
A. Spotlight
B. Roof
C. Tower
Parts
• Locate the battery compartment on the tower.
• Loosen the screw in the battery compartment
door with a Phillips screwdriver. Remove the
battery compartment door.
• Insert three “AAA” (LR03) alkaline batteries.
We recommend the use of alkaline batteries
for longer battery life.
• Replace the battery compartment door and
tighten the screw with a Phillips screwdriver.
Do not over-tighten.
• When sounds become faint or stop, it’s time
for an adult to change the batteries.
• Protect the environment by not
disposing of this product with house-
hold waste (2002/96/EC). Check your
local authority for recycling advice and
facilities (Europe only).
A
BC

Assembly
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury
or ruin your toy. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-
zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove exhausted batteries from
the toy. Dispose of batteries safely. Do not dispose of the product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging.
• If removable, rechargeable batteries are used, they are only to be charged under
adult supervision.
1.5V x 3
“AAA” (LR03)
1
TOWER
ROOF
• “Snap” the roof onto the tower.
• “Snap” the spotlight into the roof.
Assembly is now complete!
SPOTLIGHT

Chimes & Music!
POWER
SWITCH
• Locate the power switch under the
archway of the lowest level.
• Slide the switch to to turn the toy on
or to °to turn the toy off.
12
• Press the doorbell to activate
the tower.
• When the train goes through the
bottom level of the tower, you’ll
hear chimes and music.
Hint: If a train does not pass through the tower after a few minutes, the tower turns off
automatically and plays a chime. Press the doorbell again activate the tower again.
IMPORTANT! The tower sound effect feature is activated by contrast in lighting. This feature
may not work if the toy is in very bright light or direct sunlight. Please keep the tower out of
bright light or direct sunlight.
PRESS

FCC Statement
United States Only
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer responsible for
compliance could void the user’s authority to operate the equipment.
Three Levels of
Track Layouts!
LEVEL
1
• To build a layout on the bottom level, just place a straight
track (sold separately) through the lowest arch in the tower.
• Use an Elevation Track Pack (sold separately) to
access the second and third levels of the tower.
• Attach a ramp assembly (sold separately)
to the middle arch to reach the ground. Use
supports and straight tracks (sold separately)
to build this elevated assembly.
LEVEL
3
• Attach a ramp assembly to a support (each
sold separately) to reach the third level.
• Use two supports (stacked up) and straight
tracks (each sold separately) to build an
elevated assembly.
LEVEL
2

Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. PRINTED IN CHINA
©2007 Mattel, Inc. All Right Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. M3234a-0920
Visit www.fisher-price.com to see
the entire world of GeoTrax®accessories!
Please keep this instruction sheet for future reference,
as it contains important information.
Requires three “AAA” (LR03) alkaline batteries (not included).
Adult assembly is required.
Tool required for battery installation: Phillips screwdriver (not included).
Wipe the toy with a clean, damp cloth. Do not immerse.