Fisher-Price STAR STATION H6723 User manual

1
H6723
J5971
Instructions
Please keep this instruction sheet for future reference,
as it contains important information.
Requires six “C” (LR14) and three “AAA” (LR03) alkaline
batteries (not included).
An adult must install batteries and set-up this system for use.
Tool required for battery installation: Phillips screwdriver
(not included).
Today’s most popular songs
sung by kids for kids™
TV not included.
TV image quality may vary.
F
e
a
t
u
r
i
n
g
h
i
t
m
u
s
i
c
f
r
o
m

2
Battery Installation
Base Unit
• Locate the battery compartment on the bottom of the
base unit.
• Loosen the screws in the battery compartment door with a
Phillips screwdriver. Remove the battery compartment door.
• Insert six “C” (LR14) alkaline batteries, as indicated inside
the battery compartment.
Hint: We recommend using alkaline batteries for
longer life.
• Replace the battery compartment door and tighten the
screws with a Phillips screwdriver. Do not over-tighten.
• When images on your TV screen appear grainy or lose
color, it's time for an adult to change the batteries!
1.5V x 6
“C” (LR14)
Shown Actual Size
Microphone
• Locate the battery compartment on the microphone.
• Loosen the screw in the battery compartment door with a
Phillips screwdriver. Remove the battery compartment door.
• Insert three “AAA” (LR03) alkaline batteries, as indicated
inside the battery compartment.
Hint: We recommend using alkaline batteries for
longer life.
• Replace the battery compartment door and tighten the screw
with a Phillips screwdriver. Do not over-tighten.
It's time for an adult to change the batteries in the
microphone when:
• Power light on microphone becomes dim.
• Sounds from the microphone become faint or stop.
• Lenses stop rotating.
1.5V x 3
“AAA” (LR03)
Shown Actual Size

3
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can cause a chemical
burn injury or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove exhausted
batteries from the product. Dispose of batteries safely. Do not dispose of the product
in a fire. The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be charged under
adult supervision.
FCC Note (United States Only)
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer
responsible for compliance could void the user's authority to operate the equipment.
StarStation™ Entertainment System
Model Number: H6723
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference and (2) this device
must accept any interference received, including interference that may cause
undesired operation.
Consumer Relations Department, 636 Girard Avenue, East Aurora, New York 14052

4
Connecting Your Star Station™to Your TV or VCR
Power/Volume
Reset
ROM
Cartridge
Special Effects Lenses
Power/Volume
Rotate Effect Lens Select
Track Forward/Back
Play/Pause
Audio/Video Cable
Important! Your TV or VCR must
have audio and video input jacks.

5
• Position Star Station™near your TV (or
VCR) or on the floor in front of your TV.
Important! Do not place Star Station™
on top of your TV. Keep excess cable off
the floor and out of the way.
• Make sure the power/volume dial on
Star Station™is off. The power light
should be off.
• Turn your TV or VCR off.Power/Volume
Dial
Power Light
1
2
• Locate the audio/video cable on the
back of Star Station™.
• Plug the audio/video pins into the
matching colored input jacks on your
TV or VCR (Yellow for VIDEO IN, White for
LEFT AUDIO IN and Red for RIGHT
AUDIO IN).
Note: We've included a detailed
illustration to show how to connect
Star Station™to a TV or TV and VCR.
Please refer to page 11.
3
Note: The photo above shows a combination TV/VCR/DVD with input
jacks on the front. Your TV or VCR may have input jacks on the back.

6
• Rotate the power/volume dial to turn
power on. The power light turns on.
• Turn your TV or VCR on.Power/Volume
Dial
5
• To find the picture transmitted on your
TV screen, set your TV's or VCR's mode
selector to INPUT or VIDEO IN.
• Have your child stand about 4 or 5 feet
from Star Station™.
• Move the lens up or down until your child
is visible on the TV screen.
6
• Insert the ROM cartridge into the slot in
Star Station™.
Note: For proper function, turn the
Star Station™off before inserting
ROM cartridges.
4
4 to 5 Feet

7
No Image?
If you do not see an image on your TV screen transmitted from Star Station™, try
the following:
1. Verify that your audio and video cable is fully inserted into your TV or VCR.
2.Press the channel down button on the VCR or TV and check for an INPUT channel
below channel 2.
3.Use the menu system on your TV or VCR to find INPUT or SOURCE. Change to INPUT
or SOURCE.
4.If you are still unable to see an image, refer to your TV or VCR's instruction manual.
Hints About Lighting...
Images on the TV screen look best when there is good lighting in the room where you
use Star Station™.
Make sure the light source in the room is in front or above your child.
The light source should NOT
be behind your child!
Front Lighting Overhead Lighting
Back Lighting

8
• Slide the power/volume switch on
the microphone to either low or high
volume. The power light turns on.
Hints:
- The microphone power/volume switch
controls the volume of your voice. The
volume dial on Star Station™controls
the overall volume of the music. Adjust
the overall volume on your TV.
- Be sure to slide the power/volume
switch to the off position when you
are finished.
• Press the play/pause button to start
the music. Press again to pause.
• Use the track forward and back
buttons to move ahead or back through
the songs on the ROM Cartridge.
• Start singing!
Power/Volume
Switch
Play/Pause
Button
7
8
Track
Forward/Back
Power Light

9
• Star Station™features five special
effects lenses.
• Press the lens button on the micro-
phone to select from the five lenses.
• Press the rotate effect button to
rotate the lens for different cool looks!
9
Lens Select
Rotate Effect
Star Clear Color Warp
Double Vision Kaleidoscope
Notes:
• To prevent battery drain, turn power/volume dial off when toy is not in use .
• If power light is on and there is no sound or picture, press reset button to
reactivate toy .
• When you are finished with Star Station™, turn off power on the main unit
and microphone.

10
If Star Station™is connected to your VCR,
you can record performances. Simply insert
a blank tape and press record on your VCR.
Recording Your Performances
Star Station™can be connected to an
external music source such as a portable
CD player or stereo so you can sing along to
other music!
1. Turn the power/volume dial on the
Star Station™off.
2.Remove the ROM Cartridge from
Star Station™.
3.Connect an audio cord (not included) to
the LINE OUT jack on your external music
source. The audio cord should have a
1/8” stereo (mini) plug.
Note: You can purchase audio cords in an
electronics or some department stores.
4.Insert the 1/8” stereo plug into the INPUT socket
on the back of Star Station™.
5.Press play on your external music source.
6.Turn Star Station™ power on.
7. Adjust volume on your external music source.
Connection to an External Music Source
Additional ROM
Storage
1/8” Stereo
(mini) Input
1. Wipe this product with a clean cloth dampened with a mild soap and water solu-
tion. Do not immerse this product.
2.This product has no consumer serviceable parts. Do not take this product apart.
Care
VCR not included.
CD player and audio cord
not included.