Fisher-Price T4337 User manual

Please keep this instruction sheet for future reference,
as it contains important information.
Requires three “AA” batteries (included) for operation.
Adult assembly is required. Tool required for assembly: Phillips screwdriver (not included).
Wipe this toy with a clean, damp cloth. Do not immerse.
This toy has no consumer serviceable parts. Do not take this toy apart.
www.fisher-price.com
T4337
T
4
3
3
7

2
Parts
Front Legs
Body
4 Feet
Inflatable Ball
Rear Legs
#8 x ¾" Screw - 5
Tighten all screws with a Phillips
screwdriver. Do not over-tighten.
Assembly
CAUTION
This product contains small
parts in its unassembled state.
Adult assembly is required.
1
2
Turn the assembly over.•
Hint: Be sure to place the assembly on a
protective surface to prevent scratching.
Insert a screw into the hole near the front•
legs and tighten.
Screw
BOTTOM VIEW
1
1
Fit the tab on the front legs into the•
opening under the head on the body.
Push the front legs into the opening.
Hint: This may require some force.
Body
Front Legs

3
Squeeze the stem on the ball to inflate it.•
Fit the T-end of the ball strap up through•
the slot under the assembly.
1
5
1
4
Fit the feet onto the end of each leg. Push to•
“snap” each foot in place.
Hint: Each foot is designed to fit one way.
If it does not seem to fit, turn it around
and try again.
1
3
Fit the rear legs into the body, as shown.•
Insert the four screws into the holes near•
the rear legs and tighten.
Rear Legs
Feet
Feet
Assembly
BOTTOM VIEW

4
Battery
Replacement
For best performance, we recommend
replacing the batteries in this toy with
three, new “AA” (LR6) alkaline batteries.
Locate the battery compartment on the•
bottom of the toy.
Loosen the screws in the battery•
compartment door and remove the door.
Remove the exhausted batteries and•
throw them away.
Insert three, new “AA” (LR6)•
alkaline batteries.
Hint: We recommend using alkaline
batteries for longer battery life.
Replace the battery compartment door•
and tighten the screws.
If this product begins to operate•
erratically, you may need to reset the
electronics. Slide the power/volume
switch off and then back on.
When sounds or lights become faint or•
stop, it’s time for an adult to change
the batteries.
1,5V x 3
“AA” (LR6)
Protect the environment by not•
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).
In exceptional circumstances, batteries
may leak fluids that can cause a chemical
burn injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of
non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of this
product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
Battery Safety
Information

5
Slide the power/volume switch to ON with low volume•
or ON with high volume .
Spin the roller ball or press the lion’s nose to watch the•
lights, and listen to fun songs and silly sounds!
Spin the roller balls, slide the ladybug or press the pop-up•
pegs for even more fun!
When you are finished playing with this toy, slide the•
power/volume switch OFF .
Sit, Crawl & Cruisin’ Fun!
Power/Volume Switch

Consumer Information
FCC Statement (United States Only)
This equipment has been tested and found
to comply with the limits for a Class
B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed
to provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may
cause harmful interference to
radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Note: Changes or modifications not
expressly approved by the manufacturer
responsible for compliance could void the
user’s authority to operate the equipment
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) this device
may not cause harmful interference
and (2) this device must accept any
interference received, including interference
that may cause undesired operation.
CO
N
S
UMER
ASS
I
S
T
A
N
C
E
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa, B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
ICES-003
This Class B digital apparatus complies•
with Canadian ICES-003. Operation is
subject to the following two conditions:
(1) this device may not cause harmful
interference and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
NMB-003
Cet appareil numérique de la classe•
B est conforme à la norme NMB-003
du Canada. L’utilisation de ce dispositif
est autorisée seulement aux conditions
suivantes: (1) il ne doit pas produire
de brouillage et (2) l’utilisateur du
dispositif doit être prêt à accepter tout
brouillage radioélectrique reçu, meme
si ce brouillage est susceptible de
compromettre le fonctionnement
du dispositif.
Fisher Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2010 Mattel, Inc. All Rights Reserved. ®
and
™designate U.S. trademarks of Mattel, Inc.
PRINTED IN MEXICO T4337a-0920