FRAME IT ALL 300001178 User manual

300001178
300001179
SPLIT WATERFALL TRI-LEVEL
RAISED GARDEN BED
Customer Service: 1800-914-9835 | su[email protected]
© 2020 Frame It All. All Rights Reserved.
Tools needed: Hammer (to tap stake in place), Hackshaw (optional)
KIT CONTAINS:
Straight Composite
Timbers x 20
Stacking
Brackets x 56
Plugs x 112
Caps x 12
Stake x 28
Layout your timbers along the borderline
and connect each timber together by
inserting the top of the stake through the
bracket loops with the stake pointing to the
sky. This enables you to freely position your
border to get your desired location.
Curved Composite
Timbers x 8

Customer Service: 1800-914-9835 | su[email protected]
ASSEMBLY INSTRUCTIONS
STEP 1: Assemble 20 x Doubled-Bracket Straight Timbers (S)
Attach one single stacking bracket to each end of timbers (both facing up – shown
below).
You will need 10 (S) Timbers for the 1st (base) level, 6 (S) Timbers for the 2nd level, 2
(S) timbers each for 3rd and 4th levels.
STEP 2: Assemble 8 x Doubled-Bracket Curved Timbers (C)
Attach one single stacking bracket to each end of timbers (both facing up – shown
below)
You will need 2 (C) Timbers each for the base, 2nd, 3rd and 4th levels.
STEP 3: Arrange 10 (S) and 2 (C) Timbers to create the base level of your garden in a
straight L- shape with the curved timber facing each end – shown below. Insert one
stake through the brackets and into each of the corners to lock all sides in place.
X 20
Note:
If you plan to assemble raised
bed on a hard surface, use
hacksaw to remove the spike of
each stake. Use these cut down
stakes for the base level only of
your raised garden.
Trim stake spike with
hacksawfor use indoor
or on hard surfaces
X 8
X 12
C
C

Customer Service: 1800-914-9835 | [email protected]
STEP 4: Arrange 6 (S) and 2 (C)
Timbers to create the 2nd level with
the curved timber facing each end.
ASSEMBLY INSTRUCTIONS
Use plugs (included)
to cover the holes on
both side of timbers
Use plugs to cover
the holes – two
plugs are required
per bracket (1 on
each side)
Use a Finishing
Cap to complete
the top level.
Use an Anchor
or Stacking Joint
for ground level
frames or borders.
Use only Stacking
Joints when
creating additional
levels.
When creating a
multi-level frame
use a Stacking
Joint.
Stacking Joints fitinto
the tops of Anchor
Joints and other
Stacking
Joints
How the Joints Work
STEP 6: Add the caps to each of the top corner joints and plugs to cover the holes on
both side of timbers.
STEP 5: Arrange 2 (S) and 2 (C)
Timbers each to create the 3rd and 4th
level with the curved timber facing
each end.
C
C
C
C
HAPPY GARDENING!!