Front Runner SLIMPRO KVXS006 Manual

ENG
KVXSUNNI_REV_A00 © 2022 FRONT RUNNER VEHICLE OUTFITTERS
1
Don’t be a hero and muscle through this installation without reading these fitting instructions first! Improper installation of this gear may void certain
aspects of your warranty.
Before you begin, take a moment and open all your Front Runner Rack Kit boxes and gather the assembly instructions for the various components.
A complete kit will contain:
1. Front Runner Mounting System specific to your vehicle
2. Front Runner Rack Tray or Load Bar Slats
This document will guide you through the assembly of the Mounting System and assist you in fitting the Rack tray or Load Bars to your specific vehicle.
Please refer to the next page for a list of all the components, quantities and tools required.
KVXSUNNI
READ ME FIRST
START HERE!
front runner SLIMPRO VAN RACK EXPEDITION RAILS
IMPORTANT WARNING!
IT IS CRITICAL THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR VEHICLE. IMPROPER ATTACHMENT COULD
RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH. YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT
RUNNER PRODUCTS TO YOUR VEHICLE, CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR AND
DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS AND PRECAUTIONS SUPPLIED WITH YOUR FRONT RUNNER PRODUCT PRIOR TO
INSTALLATION OR USE. IF YOU DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY
FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER OR OTHER QUALIFIED PERSONNEL.
NOTE: Front Runner will not be responsible for any damage caused by the failure to install the product according to these instructions.
Please call us if you have any questions about the installation of this product.

KVXSUNNI_REV_A00 © 2022 FRONT RUNNER VEHICLE OUTFITTERS 2
TOOLS NEEDED
FIGURE 1.1
CHECK ONLINE FOR THE LATEST FITMENT GUIDE WWW.FRONTRUNNEROUTFITTERS.COM
GET ORGANIZED
1
IN THE BOX
KVXS006 Please See Page 3 Table 1
KVXS007 Please See Page 3 Table 2
KVXS008 Please See Page 3 Table 3
KVXS009 Please See Page 3 Table 4
KVXS010 Please See Page 4 Table 1
KVXS011 Please See page 4 Table 2
5mm Friend
4
3
5
7
1
2
6
Diagram for illustration
purposes only

© 2022 FRONT RUNNER VEHICLE OUTFITTERS
3 KVXSUNNI_REV_A00
GET ORGANIZED
1
1 2 X LH / RH Drop Set
2 3 X Expedition Rail Joiner
4 1 X Rail Tubing (460mm)
7 1 X Expedition Rail Fastner kit
KVXS006 IN THE BOX
1 2 X LH / RH Drop Set
2 3 X Expedition Rail Joiner
5 1 X Rail Tubing (503mm)
7 1 X Expedition Rail Fastner kit
KVXS007 IN THE BOX
1 1 X LH / RH Drop Set
2 4 X Expedition Rail Joiner
3 1 X Rail Tubing (435mm)
7 1 X Expedition Rail Fastner kit
KVXS008 IN THE BOX
IN THE BOX
1 1 X LH / RH Drop Set
2 3 X Expedition Rail Joiner
6 2 X Rail Tubing (700mm)
7 1 X Expedition Rail Fastner kit
KVXS009 IN THE BOX
#
#
#
#
QTY
QTY
QTY
QTY
4
2
1
7
5
2
1
7
3
2
1
7
6
2
1
7

© 2022 FRONT RUNNER VEHICLE OUTFITTERS
4 KVXSUNNI_REV_A00
GET ORGANIZED
1
1 2 X LH / RH Drop Set
2 5 X Expedition Rail Joiner
4 1 X Rail Tube (460mm)
6 1 X Rail Tube (700mm)
7 1 X Expedition Rail Fastner kit
KVXS010 IN THE BOX
1 2 X LH / RH Drop Set
2 6 X Expedition Rail Joiner
5 2 X Tube (503mm)
7 1 X Expedition Rail Fastner kit
KVXS011 IN THE BOX
#
#
QTY
QTY
IN THE BOX
6
1
2
7
5
2
1
7
4

KVXSUNNI_REV_A00 © 2022 FRONT RUNNER VEHICLE OUTFITTERS
5
FIT AND SECURE
2
3 4 5 6
2.1
2.2
2.3
Remove the end cap and pre-assemble
Items 1 and 7 before sliding the assembly
into the side profile.
Adjust Items 3,4,5,6 so that it fits on items 1
and 2.
After all the parts have been adjusted
correctly, tighten all the fastners, and
make sure it is secured.
3 4 5 6
2
1
Determine where you want to mount your Expedition Rail Kit,
Keep in mind that you migh have to remove some slats and rearrange the slats and
Expedtion Rail Feet to fit the Expedition Rail Kit.
1
7
7
3 4 5 6
1
2
5mm
5mm