Front Runner SHOWER ARM MKII User manual

RRAC028_REV_A00 © COPYRIGHT 2016 FRONT RUNNER VEHICLE OUTFITTERS
Shower arm mkii
RRAC028
ENG
1
15 min
IMPORTANT WARNING!
IT IS CRITICAL THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR VEHICLE.
IMPROPER ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH.
YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT RUNNER PRODUCTS TO YOUR VEHICLE. CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR AND DAMAGE.
THEREFORE YOU MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS AND PRECAUTIONS SUPPLIED WITH YOUR FRONT RUNNER PRODUCT PRIOR TO INSTALLATION OR USE.
IF YOU DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY FAMILIAR WITH THE INSTALLATION PROCEDURES,
YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER OR OTHER QUALIFIED PERSONNEL.
Thank you for purchasing a Front Runner Shower Arm MKII.
Before you start, take a moment to familiarize yourself with this Fitting Instruction and the components received.
Refer to Page 2 for a list of all the components, quantities and tools required.
READ ME !

RRAC028_REV_A00 2 © COPYRIGHT 2016 FRONT RUNNER VEHICLE OUTFITTERS
1
2
3
4
5
6
TOOLS NEEDED
13MM 13MM
1 1 X Shower Arm
2 2 X M8 Nut Cap
3 2 X M8 Nyloc Nut
4 2 X M8 x 16 x 1.6 SS Flat Washer
5 1 X Shower Mount
6 2 X M8 x 16 Hex Bolt
IN THE BOX
FIGURE 1.1
GET ORGANIZED
1
Here is what you are looking at for RRAC028

RRAC028_REV_A00 3
3
6
5
4
FIT AND SECURE
2
2.2
2.3
2.4
2.1
2.1
2.2
2.3
Find a suitable place to mount the shower
arm.
Slide two M8 x 16 hex bolts (Item 6) into
the T-slots as shown.
Place the shower mount (Item 5) over the
two M8 x 16 hex bolts with the round bar
toward the outer edge of the rack. The
bracket must be 4mm from the inside face
of the rack side.
Fasten in position using the M8 flat washer
(item 4) and M8 nyloc nut (Item3).
13MM
13MM
The shower arm fits to the shower
mount by sliding the slots in the shower arm
into the rod of the shower mount.
When in use it is unfolded out to the
open position.
Open
Bracket to hold shower head.
Closed
THE SHOWER ARM MUST BE REMOVED
FROM THE SHOWER MOUNT WHEN THE
SHOWER IS NOT IN USE AND STORED IN
YOUR VEHICLE.

RRAC028_REV_A00 © COPYRIGHT 2016 FRONT RUNNER VEHICLE OUTFITTERS 4
Congratulations. You did it. Take a step back and admire your work!
COMPLETION
3
3.1
INSTALL OTHER VEHICLE AND RACK ACCESSORIES
4
Now's the time to visit your favorite Front Runner Dealer in person or Online.