FURNITUREBOX GIOVANI 4 User manual

GIOVANI 4
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips, advice
and assembly video or visit
furniturebox.co.uk/club/giovani-4
SCAN ME

• Check you have all the components and
tools listed.
• Remove all fttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from the
work area, small parts could cause choking
if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly. In
some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
TWO
PERSON
45 MINUTE
BUILD
MAXIMUM
CAPACITY 100Kg

Follow us on Instagram
@furniturebox_uk
STEP 2
ATTENTION: Carefully turn
over connecting board
and halo. Align connecting
board with table top. Attach
connecting board to table
top using 4x screw [C] and
4x washer [B]. Tighten using
allen key [D].
STEP 1
Use a clear, at, soft surface
to avoid bumps or scratches.
Attach ‘halo’ to connecting
board using 4x screw [A]
and 4x washer [B] . Tighten
with allen key [D].
ATTENTION: To ensure table
stability, please make sure
you have fully tightened the
halo to the connecting plate.

www.furniturebox.co.uk
STEP 3
Attach table base to halo
using 4x screw [A] and 4x
washer [B]. Tighten with
allen key [D], then add 4x
anti-slip feet [E] to corners of
table base.
STEP 4
ATTENTION: With the help
of another person, carefully
turn the table over to
complete assembly. Your
table is now ready to use
FULL ASSEMBLY INSTRUCTIONS

www.furniturebox.co.uk

The cushions (foam inserts and
covers) are not covered by the guarantee.