FURNITUREBOX SIENA CONSOLE User manual

SIENA CONSOLE
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips,
advice and assembly video or visit
furniturebox.co.uk/club/siena-console
SCAN ME

• Check you have all the components and
tools listed.
• Remove all fttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from
the work area, small parts could cause
choking if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly.
In some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
30 MINUTE
BUILD
ONE
PERSON
MAXIMUM
CAPACITY 80Kg
IMPORTANT
STEP

Follow us on Instagram
@furniturebox_uk
STEP 1
Put the pieces on a soft at
surface e.g. a carpet to avoid
scratching or bumping. Install
the threaded rods (A) into the
corresponding holes on the
top board (1) and the side-
shelf board (2). Then install
the wooden dowels (B) in the
corresponding holes on side
- support board (4).
ATTENTION: Be careful
not to over-screw beyond the
thread stops.
STEP 2
Assemble the side-support board (4), stainless steel pole (5) and
the top board (G) together as shown. Then assemble the side-shelf
board (4). Screw in and x these pieces together using the spanner
(E) provided, locking in place with nut (C) and metalwasher (D)

www.furniturebox.co.uk
STEP 3
Using the same method as Step 2, assemble the bottom
board (3), side-support board (4) and stainless steel pole (5)
together. Add on the stick on the waterproof rubber washer
(F) to the bottom of board (3).
STEP 4
ATTENTION: With help,
turn console around to
complete assembly.
FULL ASSEMBLY INSTRUCTIONS

www.furniturebox.co.uk

The cushions (foam inserts and
covers) are not covered by the guarantee.