FURNITUREBOX LEONARDO 4 User manual

LEONARDO 4
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips, advice
and assembly video or visit
furniturebox.co.uk/club/leonardo-4
SCAN ME

• Check you have all the components and
tools listed.
• Remove all fttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from
the work area, small parts could cause
choking if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly.
In some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
TWO
PERSON
MAXIMUM
CAPACITY 100Kg
45 MINUTE
BUILD
GLASS

Follow us on Instagram
@furniturebox_uk
STEP 2
Place the table legs over
the rods on to the metal
discs. Use 4 x nuts [B] to
secure table legs to table
top. Repeat for all 4 table
legs. ATTENTION: Be
careful not to fully tighten
xings yet.
STEP 1
Use a clear, at, soft surface to
avoid bumps or scratches. Place
the table top on the oor with
the metal discs facing up. Screw
4 x rods [A] in to the metal discs.

www.furniturebox.co.uk
STEP 3
Add feet [C} to bottoms
of table legs.
Connect all four legs
together in the middle
using the connecting
piece [H], washers [D]
screws [E]. Tighten with
Allen key [G].
Once connecting piece
[H] is secured, you can
then tighten all the
table legs to the table
top with wrench [F].
STEP 4
ATTENTION: With help
arefully, and with help, turn
your completed table over
so it’s now the correct way
up. Ensure stability.
FULL ASSEMBLY INSTRUCTIONS

www.furniturebox.co.uk

The cushions (foam inserts and
covers) are not covered by the guarantee.