FURNITUREBOX KYLO CONSOLE TABLE User manual

KYLO CONSOLE
TABLE
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips, advice
and assembly video or visit
furniturebox.co.uk/club/kylo-console
SCAN ME

• Check you have all the components and
tools listed.
• Remove all ttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from the
work area, small parts could cause choking
if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly. In
some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
TWO
PERSON
MAXIMUM
CAPACITY 100Kg
30 MINUTE
BUILD

Follow us on Instagram
@furniturebox_uk
STEP 1
Use a clear, at, soft surface to avoid
bumps or scratches.
Attach leg frame part [2] to leg frame part
[4] using 2 x washer [B] followed by 2 x
screw [A] and tighten with Allen key [E}.
STEP 2
Attach leg frame part [4] to leg
frame part [3] using 2 x washer
[B] followed by 2 x screw [A] and
tighten with Allen key [E].

www.furniturebox.co.uk
STEP 3
Attach leg frame part [1] to the rest
of the leg frame using 2 x washer
[B] followed by 2 x screw [A] at each
corner. Tighten with Allen key [E].
STEP 5
ATTENTION: Carefully, and with help,
turn your table over so it rests on its
base. Check for stability. Your console
table is now ready to use.
STEP 4
Place tabletop [5] face down on a soft, at
surface. Attach leg frame to tabletop 2 x
washer [D] followed by 2 x screw [C] on each
side of the leg frame. Tighten all screws
with Allen key [F].
FULL ASSEMBLY INSTRUCTIONS

www.furniturebox.co.uk

The cushions (foam inserts and
covers) are not covered by the guarantee.