GMI CBL-5464-12.S User manual

CBL-5464-12.S
TOOLS REQUIRED FOR ASSEMBLY
Socket set, Open end wrench set, Cordless drill with
3/8" socket bit (Magnetic recommended).
BEFORE ASSEMBLING THE WORKBENCH
Assembly of this bench will require 2 people.
Read through the assembly instructions to
familiarize yourself with the order in which the
parts are assembled. We suggest that you clear
& vacuum the area where the bench is to be
assembled. It is important that the bench is
assembled in the same sequence as instructed.
HARDWARE & GMI COMPONENTS
All assembly hardware is provided.
STEP 1
**Units are difficult to move once assembled.
Begin assembly in the bench's final location**
CAUTION: If cabinets are numbered. Be sure
to keep the cabinets in sequential order.
Each station contains 6 individual locker cabinets.
First connect the cabinets side-to-side using (16) lock
nuts and bolts (4 bolts/nuts to connect a pair of cabinets).
Then push them back- to-back and
connect using (12) lock nuts and bolts.
HARDWARE: 3/8" x 1/2" Bolts & Lock Nuts.
Nylock Nut
3/8 x 1/2”
Hex Head Bolt

STEP 3
FOR STEEL TOPS W/ WOOD CORE:
Carefully set the top on the cabinets as
shown to the right.
Adjust top so that it sits centered on the
cabinets. Attach using (2) #14 x 1" Lag
Screws per cabinet - Some holes will not
be used.
STEP 3
FOR STEEL TOPS W/O WOOD CORE:
Carefully position the top & place on
the cabinets as shown to the right.
The top of each cabinet will have 4
holes that will align with pre-installed
threaded inserts on the bottom side of the
worksurface. Attach using 1/4-20 x 3/4”
Flange head bols (4 per cabinet).
1/4-20 x 3/4”
Flange Head Bolt