GMI PC-3000-10 User manual

PC-3000-10 Computer Workstation
TOOLS REQUIRED FOR ASSEMBLY
Electric Hand Drill, Phillips Head Bit, 3/8" Socket Bit.
BEFORE ASSEMBLING THE WORKBENCH
Read through the assembly instructions to familiarize
yourself with the order in which the parts are assembled.
We suggest that you clear & vacuum the area where the
bench is to be assembled.
It is important that the bench is assembled in the same
sequence as instructed.
HARDWARE
All assembly hardware is provided.
STEP 1
Secure the modesty panel to a leg as shown
on the right.
Use (2) 1/4"-20 x 1/2" Flange Head Bolts.
1/4-20 x 1/2” Flange Head Bolt
***Assembly Note***
Adjustable Height and Mobile Benches
will follow the same assembly procedure

STEP 3
Next, secure the modesty panel to the opposite leg as
shown on the right. If your work station is supplied with a
front support brace attach it to the same leg you attached
the modesty panel to in step 1. Use (2) 1/4"-20 x 1/2" Flange
Head Bolts for each side of the brace and (2) for each side
of the modesty.
STEP 4
Hang the wire management tray from the rear modesty
panel as shown. The work surface will hold the modesty
panel in place.
STEP 5
Place the work surface as shown on top of the assembled
base. The work surface contains threaded inserts to align
with the provided bypass holes in the legs. Attach the work
surface to the base using (4) 1/4-20 x 1 1/2 Flange head
bolts.
1/4-20 x 1/2” Flange Head Bolt
1/4-20 x 1- 1/2” Flange Head Bolt

STEP 6
Place the work surface as shown on top of the assembled
base. The work surface contains threaded inserts to align
with the provided bypass holes in the legs. Attach the work
surface to the base using (4) 1/4-20 x 1 1/2 Flange head
bolts.
If your work station has a front brace use (4) #14x1” Lag
Bolts to affix the brace to the work surface (all holes may
not be filled)
1/4-20 x 1- 1/2” Flange Head Bolt
#14X1” Lag Bolt
STEP 7
If you ordered the optional CPU Rack we will attach it to the
leg now. Using (4) 1/4-20 x 1/2” Flange head bolts, attach
the CPU Rack to the leg as shown.
Finish by installing the grommets into the holes provided in
the work surface if you have not already done so.