GMI SRI-205 User manual

SRI-205
TOOLS REQUIRED
FOR ASSEMBLY
Socket Set, Electric Hand Drill, Phillips Head Bit, 3/8"
Magnetic Hex Driver Bit.
BEFORE ASSEMBLING THE WORKBENCH
Read through the assembly instructions to
familiarize yourself with the order in which the parts
are assembled.
We suggest that you clear & vacuum the area where
the desk is to be assembled.
It is important that the desk is assembled in the
same sequence as instructed.
HARDWARE
All assembly hardware is provided.
STEP 1
Attach the left and right leg panels to the
modesty panel using three 1/4-20 x 3/4"
flange head bolts per side. Panels must be
oriented as shown below. Attach the
triangular shape top support bracket to the
inside of the leg as shown by the red arrow
using (2) 1/4-20 x 3/4” flange head bolts.
1/4-20 x 3/4”
Flange Head Bolt

STEP 2
STEP 3
Remove drawers from side cabinet assembly to access mounting holes. Install side cabinet by
inserting the six tabs on the side of the cabinet into the rectangle slots of the leg panel (See left
image below). It is recommended to have two people to help line up all six tabs into the leg, if
all six are not properly lined up the cabinet will not mount flush to the leg. Be sure that all six
tabs are protruding from the cabinet as pictured, it may be necessary to bend the tabs out if they
have been bent in. Once all six tabs are inserted carefully push cabinet down till top edge of
cabinet is level with the top edge of leg panel. Use four #8 x 5/8” sheet metal screws to secure
cabinet to the leg in the locations pictured in the right image below.
#8 x 5/8”
Sheet Metal Screw
Attach the return leg panel to the return modesty panel using (3) 1/4-20 x 3/4" flange head
bolts. Panels must be oriented as shown below.
1/4-20 x 3/4”
Flange Head Bolt

STEP 5
Place the desks tops on. Attach the two sections of top together
using the connector plate on the underside of the tops. Once the two
pieces are lined up use (8) #14 x 1” lag screws to join them together.
Adjust the top so there is a 1 inch overhang on the front edge of the
desk. Attach the top with #14 x 1” lag screws by screwing into
the underside of the top through the open mounting holes in
the top of the leg assemblies, modesty panels, cabinet, and triangle
support bracket. (View illustration).
Re-Install drawers once top is secured.
#14 x 1”
Lag Bolt
Top
Leg
STEP 4
Attach the return leg base assembly to the main desk leg base assembly using (3) 1/4-20 X 3/4”
flange head bolts. Panels must be oriented as shown below.
1/4-20 x 3/4”
Flange Head Bolt