GMI SR-7000 User manual

SR-7000
TOOLS REQUIRED FOR ASSEMBLY
Socket set, Open end wrench set, Cordless
drill with 3/8" socket bit (Magnetic recommended).
BEFORE ASSEMBLY
Read through the assembly instructions to
familiarize yourself with the order in which
the parts are assembled. We suggest that
you clear & vacuum the area where the bench
is to be assembled. It is important that the
bench is assembled in the same sequence
as instructed.
HARDWARE
All assembly hardware is provided.
Attach the side tables back modesty panel to the
side of the leg. Position the modesty panel
so the notch on the top of the modesty
panel is at the top of the leg so you can
access the top mounting holes of the leg.
Use (2) 1/4-20 x 1/2” flange head bolts to
mount the modesty panel to the pre-
installed nuts on the leg.
STEP 3
Notched side toward leg.
1/4-20 x 1/2”
Flange Head Bolt
Attach the low profile top modesty panels to
the main top and the arched side table top.
Use (2) 5/16 x 1-1/2” hex head bolts, flat
washers and lock washers per panel.
Bolt from the bottom of the top through
the pre-drilled holes in the top and into the
pre-installed nuts in the bottom of the panel.
STEP 1
5/16-18 x 1-1/2”
Hex Head Bolt
5/16 Flat Washer
5/16 Lock Washer
Attach the main top to the cabinet. Center the
top front-to-back and side-to-side. From inside
the cabinet attach the top using (10) #10 x 5/8”
Spax wood screws in the holes around the
perimeter of the cabinet and into the bottom of
the top.
STEP 2
#10 x 5/8”
SPAX Wood Screw

Attach the modesty panel and leg
assembly to the side of the cabinet.
Take care not to bend the modesty
panel before the counter can be
mounted as it provides support.
Use (2) 1/4-20 x 1/2” flange head bolts to
mount the modesty panel to the pre-
installed nuts on the side of the cabinet.
STEP 6 STEP 5
Attach the angled side table counter top mounting
bracket to the side of the main cabinet.
Use (3) 1/4-20 x 1/2” flange head bolts to
mount the bracket.
1/4-20 x 1/2”
Flange Head Bolt
1/4-20 x 1/2”
Flange Head Bolt
STEP 4
Thread the stem of the caster into the bottom
side of the leg and tighten. If not installed on the
main cabinet portion of the desk those four casters
can be installed at this point also using the same
method.

STEP 7
Position the top on the leg/modesty panel
assembly and angle bracket. The top should be
centered front-to back and flush up against
the side of the main cabinet.
Attach the top using (11) #10 x 5/8”
Spax wood screws. Eight screws in the leg
and 3 screws for the angle bracket.
#10 x 5/8”
SPAX Wood Screw
Front