Goldmedal Pop Maxx Series User manual

Part No. 49749
Pop Maxx
Instruction Manual
Models: 2552, 2552KC, and 2552LS
Total Restaurant Supply - https://totalsupply1.com - Toll Free 1-800-944-9304 - Local 507-288-9454
2940 Hwy 14 W, Rochester, MN 55901

SAFETY PRECAUTIONS
Total Restaurant Supply - https://totalsupply1.com - Toll Free 1-800-944-9304 - Local 507-288-9454
2940 Hwy 14 W, Rochester, MN 55901

Pop Maxx
Models #2552, #2552LS, #2552KC,
3
Forward
This manual covers the 12/14 oz. Pop Maxx Popcorn Machine, model number 2552, 2552LS, 2552KC.
Installation Instructions
Inspection of Shipment:
Unpack all cartons and check thoroughly for any damage that may have occurred during transit.
Damage claims should be filed immediately with the transportation company. Gold Medal is not
responsible for damage that occurs in transit.
Setup:
Your new Pop Maxx Popcorn Machine is completely assembled and tested at the factory.
Remove all packing material and tape before starting operation.
Electrical Requirements:
The following power supply must be provided:
Model No. 2552: 120 VAC, 60 Hz. 1440 Watts 12 Amps
Model No. 2552LS: 120 VAC, 60 Hz. 1480 Watts 12.3 Amps
Model No. 2552KC: 120 VAC, 60 Hz. 1440 Watts 12 Amps
.
Your electrician must furnish sufficient current for proper machine operation. We recommend this
popper be on a dedicated and circuit protected line. Failure to wire properly will void the warranty
and can result in damage to the heat elements, light, motor and etc.
It is Gold Medal Products Company’s recommendation that this machine be plugged directly into a
wall outlet. The use of extension cords is not recommended due to safety reasons and the popper’s
performance will be sacrificed/reduced.
Before You Plug In Machine:
1. Make sure that the wall outlet can accept the three (3) prong grounded plug on the power supply
cord.
2. The wall outlet must have the proper polarity. If in doubt, have a competent electrician inspect the
outlet and correct if necessary.
3. DO NOT use a three (3) prong grounded to two (2) prong un-grounded adapter.
Total Restaurant Supply - https://totalsupply1.com - Toll Free 1-800-944-9304 - Local 507-288-9454
2940 Hwy 14 W, Rochester, MN 55901

Pop Maxx
Models #2552, #2552LS, #2552KC,
4
Operating Instructions
Controls and Their Functions
Light & Warmer Switch
This switch operates the overhead light and corn deck freshener heat element.
Kettle Motor Switch
This switch operates the popcorn agitator shaft. This switch must be ON at all times when
popcorn (popped and un-popped) is present in the kettle.
Kettle Heat Switch
This switch turns on the heat element located in the popcorn kettle.
Kettle Heat
Switch
p/n 42798
Lights/Warmer
Switch
p/n 42532
Kettle Motor
Switch
p/n 42532
Total Restaurant Supply - https://totalsupply1.com - Toll Free 1-800-944-9304 - Local 507-288-9454
2940 Hwy 14 W, Rochester, MN 55901

Pop Maxx
Models #2552, #2552LS, #2552KC,
5
Amount of Popcorn and Oil:
Your new popper is equipped with a corn, salt, and oil measure. We recommend flavored and
colored coconut oil. Popcorn popped in coconut oil stays fresh longer and does not leave black
deposits in your kettle like other oils. Use only top quality fresh hybrid popcorn from reputable
suppliers.
Corn charge – 12 oz./14 oz.
Oil charge – 3.5 oz./4.2 oz.
Flavacol – 14.7 cc (measure included with accessory kit)
*for best results use mega-pop premeasured pouches (item # 2839)
Popping Instructions:
1. Turn both the KETTLE HEAT and KETTLE STIR MOTOR switches ON.
2. Test pop three (3) kernels of corn and one ounce (1 Oz.) of popping oil. When the kernels pop,
the kettle is ready for use.
3. Load both a full corn/oil charge and Flavacol Seasoning Salt into the kettle. Close the lids.
4. When the corn has finished popping, gently dump the kettle.
5. Repeat the cycle, starting with step number 3, until the desired amount of popcorn has been
achieved. Always pop 3 to 5 consecutive batches for the best popcorn.
On the final kettle of corn, it is a good idea to turn the KETTLE HEAT switch OFF just as the lids are
forced open by the popping corn. This procedure saves electricity since the kettle has plenty of heat
and eliminates smoke/odor from any oil residue that remains after you have stopped popping.
Pappy’s Kettle Corn Instructions
1. Turn kettle heat, stir motor, and lights to the ON position
2. First Batch Online: pre-heat kettle for 4 minutes.
3. Add 3/8 part oil and 1 part popcorn into the kettle (No Salt!). Start timer for 45-60 seconds.
4. Add 2/3 part Pappy’s into kettle when timer goes off. If popping has just started, close the right
door and carefully/quickly add the Pappy’s mix through the left door. Re-open right door.
5. Dump Kettle when popping has nearly stopped, repeat steps 3 and 4. Salt and mix the popped
corn thoroughly. Pop at least 5 batches.
Total Restaurant Supply - https://totalsupply1.com - Toll Free 1-800-944-9304 - Local 507-288-9454
2940 Hwy 14 W, Rochester, MN 55901

Pop Maxx
Models #2552, #2552LS, #2552KC,
6
Count Down timer Instructions
1. Press MIN and SEC together to reset timer to zeo.
2. Use MIN and SEC buttons to set time.
3. Press START button to start or stop.
4. The alarm will sound for 60 seconds or press any key to stop alarm. The timer will return to the
set time.
5. Timer part number - 63012
Total Restaurant Supply - https://totalsupply1.com - Toll Free 1-800-944-9304 - Local 507-288-9454
2940 Hwy 14 W, Rochester, MN 55901

Pop Maxx
Models #2552, #2552LS, #2552KC,
7
Care And Cleaning
After completion of a series of popping, wipe the outside of the kettle with a soft cloth to remove any
oil drippings/residue. DO NOT let this residue burn on! After completion of popping for the day, let
the kettle cool until it is warm to the touch. Unplug the kettle and remove from machine. Use a soft
cloth to wipe out the inside of the kettle, kettle lids, kettle crossbar, agitator and all outside surfaces
of the kettle.
DO NOT immerse the kettle in water, or any other cleaning solution, this will void the warranty.
It is recommended, as a routine maintenance procedure, to use authentic Gold Medal Products
Company 2095 Heat’n Kleen inside kettle cooking surface cleaner. Heat’n Kleen will remove any
oily build-up, and helps maintain a clean cooking surface, if used on a routine basis. Heat’n Kleen
will not damage the kettle’s cook surface. Contact your local Gold Medal Products Company dealer
if additional cleaning strength is required for extremely dirty kettles.
For fresh corn tomorrow, remove all popped popcorn and place in a clean sealed food container.
The container must be suitable for direct food contact.
Clean the glass and all interior/exterior cabinet surfaces using Gold Medal’s non-ammonia watchdog
glass cleaner – item #2588. A regularly cleaned machine is easier to keep clean. In addition, a clean
machine is more appealing to both customers and increases sales. Your local food service
inspectors appreciate a clean machine.
NOTE: DO NOT use any cleaners that contain ammonia. Ammonia based cleaners may crack
and/or fog the plastic parts/doors on the machine.
Total Restaurant Supply - https://totalsupply1.com - Toll Free 1-800-944-9304 - Local 507-288-9454
2940 Hwy 14 W, Rochester, MN 55901

Pop Maxx
Models #2552, #2552LS, #2552KC,
8
Filter Cleaning Instructions
Your popcorn machine is equipped with an efficient and durable filtration system. However, the
filter should be cleaned every 1-2 weeks to maintain efficiency. Follow the steps below for
proper filter cleaning:
1. The filter is located on the inside of the popcorn machine, directly above the popping
kettle.
2. Remove the filter by gripping the filter itself, and pulling straight down. (As shown
below.)
1. Clean the filter in warm soapy water, and allow to dry overnight. Replace the filter by
putting it into the slot, and pushing upward. (As shown below) Make sure the filter frame
is flush with the roof of the machine. (As shown above)
Total Restaurant Supply - https://totalsupply1.com - Toll Free 1-800-944-9304 - Local 507-288-9454
2940 Hwy 14 W, Rochester, MN 55901

MAINTENANCE INSTRUCTIONS
Total Restaurant Supply - https://totalsupply1.com - Toll Free 1-800-944-9304 - Local 507-288-9454
2940 Hwy 14 W, Rochester, MN 55901

ORDERING SPARE PARTS
* Always speak to a Gold Medal Products Technical Service Advisor before
ordering any parts to help ensure accuracy for your product. Included
diagrams may not be the latest information.
1. Identify the needed part by checking it against the photos, illustrations, and/or parts list.
2. When ordering, please include part number, part name, and quantity needed.
3. Please include your model name, serial number, and date of manufacture (located on
the machine nameplate) with your order.
4. Address all parts orders to:
Parts Department
Gold Medal Products Co.
10700 Medallion Drive
Cincinnati, Ohio 45241-4807
Or, place orders by phone or online:
[phone]
[phone]
Fax: [phone]
E-mail: [email protected]
Web Page: www.gmpopcorn.com
Total Restaurant Supply - https://totalsupply1.com - Toll Free 1-800-944-9304 - Local 507-288-9454
2940 Hwy 14 W, Rochester, MN 55901