Grange TRADITIONAL PERGOLA User manual

PKTRADA - 279.8cm [H] x 270cm [W] x 270cm [D]
TRADITIONAL
PERGOLA
Self-Assembly required Home Delivery available
www.grangefen.co.uk
All products and related emblems featured
are trademarks of Grange Fencing Ltd.
©2016 Grange Fencing Ltd
All rights reserved.
In line with the Company’s policy of
continuous product development, the
right is reserved to change and improve
product design without prior notice.
CODE: PKTRADA
PLAN
FOOTPRINT
193cm
270cm
183cm SQ.
270cm SQ.279.8cm
183cm SQ.
Traditional Pergola [A5 labels-Dec'16]] 4/5/17 16:31 Page 1

ASSEMBLY INSTRUCTIONS
TRADITIONAL PERGOLA PRESSURE TREATED GREEN
PARTS LIST
HARDWARE PACK
Posts [ATPOST9] x 4
Rafters x 8
Screws - 5mm x 7cm x 8
[x]
Screws - 4mm x 4cm x48
[y]
Metal Brackets x12
[z]
Tools Required: Posidrive Screwdriver
BEFORE YOU START
•Check the pack/s and make sure that you have all of the parts listed
above. If not, contact your retailer who will be able to help you.
•When you are ready to start, make sure you have the right
tools to hand, plenty of space and a clean, dry area for assembly.
It is advisable for two people to carry out the work
SITE PREPARATION
Excavate a 30cm square hole (approx)
for each post to a depth of at least
30cm.(see Fig.A right)
This will give your structure adequate
stability. Fig A.
30cm
A
B
B
A
ASSEMBLY
To ensure longevity of your structure it is recommended
that it is treated with a wood preservative on a yearly basis.
AFTERCARE
1. The Structure is spaced to allow standard Grange
panels to be inserted, if preferred, to provide a
screen. The distance between each of the posts is
therefore 183cm (see Fig.1)
2. It is advisable to mark each of the Rafters (B),
used as supports, where the roof rafters will be
fixed, before beginning assembly. For the
suggested spacing see Fig.2.
3. Decide on the orientation of the structure.
4. Position two of the Posts (A)to enable one of the
Rafters, previously marked, to be fitted. Ensure
the distance between the two Posts is set at
183cm before fixing the rafter in position with
screws (x).
5. Repeat step 4 for the second pair of Posts.
6. Using one of the remaining Rafters, fix it at one of
the end points on one of the assemblies, using
the Metal Brackets (z)as Fig.3.
7. Then fix the other end of the Rafter to the other
assembly at the corresponding point.
8. Repeat steps 6 & 7 at the opposite end of the
structure so that it is able to stand upright.
Ensure itis level and upright by adjusting posts.
9. When this has been carried out, the remaining
Rafters may be fixed using the Metal Brackets at
the positions previously marked.
10. Re-check that the structure is level and upright.
(see Fig.4)before fixing the posts permanently.
=
=
Fig.4
Fig 2.
380380380
measured between rafter centres
400 400380 380
Fig.3
z
B
B
A
B
B
A
Traditional Pergola [A5 labels-Dec'16]] 4/5/17 16:31 Page 2