Grange ELITEARCH User manual

ELITEARCH - 250cm [H] x 100cm [W] x 44.5cm [D]
ELITE GARDEN ARCH
Self-Assembly required Home Delivery available Pre-Painted available
CODE: ELITEARCH
PLAN
44.5cm
100cm
pathsup to 89.5cm
44.5cm
200cm50cm
www.grangefen.co.uk
All products and related emblems featured
are trademarks of Grange Fencing Ltd.
©2015 Grange Fencing Ltd
All rights reserved.
In line with the Company’s policy of
continuous product development, the
right is reserved to change and improve
product design without prior notice.
Elite Arch [A4 label-assembly] 2/2/16 14:04 Page 1

ASSEMBLY INSTRUCTIONS
ELITE GARDEN ARCH PRESSURE TREATED GREEN
PARTS LIST
HARDWARE PACK
Dowling Beams x 9
Arch Side Sections x 2
Curved Roof Beams x 2
Screws 8 x 3.5cm x10
[x]
Tools Required: Posidrive Screwdriver / Electric Drill / Spirit Level
BEFORE YOU START
•Check the pack/s and make sure that you have all of the parts listed
above. If not, contact your retailer who will be able to help you.
•When you are ready to start, make sure you have the right tools to
hand, plenty of space and a clean, dry area for assembly.
It is advisable for two people to carry out the work
SITE PREPARATION
Excavate a 30cm square hole (approx) for each
post to a depth of at least 30cm. (see Fig.A right)
This will give your structure adequate stability.
Fig A.
30cm
To ensure longevity of your
structure it is recommended
that it is treated with a wood
preservative on a yearly basis.
AFTERCARE
C
B
A
ASSEMBLY
STEP 1
Take one of the Curved Roof Sections (B)and insert one of the Dowling
Beams (C)into each of the holes provided.
STEP 2
Take the second Curved Roof Section and position it
onto the free end of the Dowling Beams.
STEP 3
Carefully position the roof
assembly to enable one of
the Side Sections (A)to be
fitted. Using two screws (x)in
eachside, attach the Side
Section to theroof assembly.
Fix at the centre
of the curve either
side with one
screw (x)as
shown in Fig.1
STEP 4
Turn this assembly to allow
the other side assembly to
be fitted.
STEP 5
The arch may now be
positioned into the
prepared holes.
STEP 6
Ensure the arch is
vertical and square.
STEP 7
Fill the holes with the
chosen method of fixing.
Fig.1
Fig.2
x
x
SCREW
THROUGH
INSIDE OF
POSTS
=
=
x
AB
A
C
A
B
B
C
B
Elite Arch [A4 label-assembly] 2/2/16 14:04 Page 2