Grizzly H7728 User manual

Introduction
This rolling tool cart with tool box requires some
assembly. Follow the instructions under each
Figure on the following page.
To begin, lay out all of the parts and compare
quantities to the inventory list given below.
If you need additional help with these instructions,
call our service department at: [phone].
MODEL H7728
ROLLING TOOL CART
INSTRUCTION SHEET
COPYRIGHT © SEPTEMBER, 2005 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#DD7590 PRINTED IN CHINA
Inventory (Figure 1)
A. Tool Box w/ Upper Shelf ............................ 1
B. Side Support ............................................... 2
C. Bottom Shelf ............................................... 1
D. Vertical Support .......................................... 4
E. Handle ........................................................ 1
F. Plain Caster ................................................ 2
G. Pivoting Caster ........................................... 2
H. 8mm Hex Bolt ............................................. 2
I. 8mm Carriage Bolt ................................... 22
J. 8mm Hex Nut ........................................... 24
K. 6mm Phlps. Head Screw .......................... 16
L. 6mm Hex Nut ........................................... 16
M. 8mm Flat Washer ..................................... 24
N. Front/Back Support .................................... 2
O. Angle Bracket ............................................. 4















Figure 1. Inventory of parts.

Figure 2. Assemble casters and vertical supports
to bottom shelf.
Figure 4. Set the tool box on top of the side
supports and secure with screws, washers and
nuts.
Figure 6. Assemble the handle onto the side of
the tool box.
Figure 3. Assemble the side supports to the
vertical supports.















Figure 5. Details for assembly of the vertical
support, the upper tray and the angle bracket.