GU Electronic FORD SYNC3 TDC2 User manual

Ford Sync3 TDC2
- MODEL : FS-PAS-170830
- DATE : 2020.04.27

GU Electronic
Index
1. Main Spec
2. Block Diagram
3. Dimension
4. External Appearance
5. Connector Pin Assignment
6. Product Composition
7. DIP S/W Setting
8. Mode Change
9. Touch Control
10. OSD(On Screen Display) Control
11. Install Manual
12. Q & A

GU Electronic
1. Main Spec.1. Main Spec.
1. Input Spec. (MULTI VIDEO INTERFACE)
- 1 x Digital RGB Input (Navigation System source)
- 1 x Analog RGB Input (Navigation System output)
- 1 x CVBS(REAR CAMERA) Input. (Rear camera source)
- 1 x CVBS(FRONT CAMERA) Input. (Front camera source)
- 1 x LVDS Input. (Car Command System)
2. Output Spec.
- 1 x Vertual Analog Touch (Navigation System source)
- 1 x Uart Digital Touch (Navigation System source)
- 1 x LVDS Output (LCD Operation)
3. Power Spec.
- Input Power : 8VDC ~ 24VDC
- Consumption Power : 12Watt, Max
4. Switch Input mode
- Possible to select CAR model while switching mode by DIP S/W
- By button on the Commander in the car via CAN

GU Electronic
2. Block Diagram2. Block Diagram
Scaler
(PIP)
MCU
LVDS
TX
INTERFACE
CAR
COMMAND
SYSTEM
LVDS
CAN
EEPROM
CAN
RECEIVER
LVDS
TX
CAR
TFT-LCD
LVDS
RX
RELAY
REAR CAMERA
POWER
REAR CAMERA
LVDS
LVDS
FRONT CAMERA COMPOSITE
NAVIGATION
SYSTEM

GU Electronic
3. Dimension
164mm * 83mm * 25mm
* This can change under manufacturer’s circumstance
164mm
83mm
25mm

GU Electronic
4. External Appearance
LED DIP S/W
FRONT
IMAGE
REAR
NAVI
POWER/CAN TOUCH
Digital
RGB
LCD-OUT
LCD-IN
PROGRAM

GU Electronic
4. External Appearance
LED
DIP S/W PROGRAM
IMAGE
FRONT
REAR
RGB
NAVI
POWER/CAN TOUCH
Digital
NAVI
LCD-OUT
LCD-IN

GU Electronic
5. Connector Pin Assignment
*NAVI Connect
① R DATA (Red)
②G DATA (Green)
③B DATA (Blue)
④SYNC (White)
⑤GND (Black)
⑥DVB-T-IR
⑦DVD-IR
① ② ③ ④ ⑤ ⑥ ⑦
*Touch Connect
① Y-
②X-
③Y+
④X+
① ② ③ ④
*POWER Connect
1. ACC (Yellow)
2. ACC (Yellow)
3. Rear-DET (Brown)
4. Front-DET (Blue)
5. CAN1-L (Green)
6. CAN1-H (Orange)
7. N.C
8. N.C
1 15
2 16
9. N.C
10. N.C
11. ACC (Red)
12. Rear-VCC (Red)
13. Front-VCC (Red)
14. Mode (Green)
15. GND (Black)
16. GND (Black)

GU Electronic
6. Product Composition
Interface 1 EA
FS-PAS-170830
LVDS IN Cable 1 EA
Power Cable 1 EA
OSD Board 1 EA
RGB NAVI Cable 1 EA
LVDS OUT Cable 1 EA
Touch 변환 Cable(KD-900) 1 EA
Mode S/W 1 EA

GU Electronic
6. Product Composition
* CarPlay Set Sales(option) – KPLAY
Interface 1 EA AUX Cable 1 EA
Power Cable 1 EA HDMI Cable 1 EA
Microphone 1 EA
Bluetooth / Wifi Antenna 2EA

GU Electronic
6. Product Composition
CarPlay Main 1 EA AUX Cable 1 EA
Power Cable 1 EA
HDMI Cable 1 EA
* CarPlay(NV17) Set Sales(option)
Microphone 1 EA

GU Electronic
7. DIP S/W Setting
* ON : DOWN , OFF : UP
PIN FUNCTION DIP S/W Selection
1 NAVI ON : Not Used
OFF : Used
2 DVB-T(AV1) ON : Not Used
OFF : Used
3 DVD(AV2) ON : Not Used
OFF : Used
4 N.C
5 N.C
6
CAR type SEL Right Picture7
8
* DIP S/W Example
F150 Model
Mustang Model
RANGER Model
Vehicles that do not function as basic
DIP-SW among F150 models
Navigator 12”
Ecosport 8”

GU Electronic
8. Mode Change
Steering Wheel Button Control
Select either "Left" button or "Voice" button.
Select "Off" when not using both.
"Left" button
- Switch mode by pressing for 1.5 seconds
- Short press to switch OEM
"Voice" button
- Press Mode for 3 seconds.
- Short press to switch OEM

GU Electronic
8. Mode Change
Specific vehicle - same as F150 but not distinguishable from other vehicle
"Left" button
- Switch mode by pressing for 1.5 seconds
- Short press to switch OEM
"Voice" button
- Press Mode for 3 seconds.
- Short press to switch OEM
In this case, set DIP-SW as shown in the figure on the left.

GU Electronic
9. Touch Control
Press and hold for more than 11 seconds on
NAVI, DVB-T, DVD screen.
(Note that it only works the first time after
switching screens)
+ Touch according to the shape coordinates
.
OR
OSD menu -> Utility -> Calibration
Touch control - Calibration

GU Electronic
9. Touch Control
DVB-T/DVD Control
Press Icon
DVB-T DVD

GU Electronic
10. OSD(On Screen Display) Control
OSD control
Mode State
First Menu Second Menu Third Menu
MENU Press to display when there is no OSD
screen.
When OSD screen is on, press it to EXIT or
OFF.
SEL Item Selection, Value Selection
UP Item up
Increase selected value
DOWN Item down
Decrease selected value
MENU SEL UP DOWN

GU Electronic
First Menu Second Menu Third Menu Description
Config
NAVI-RGB DIGTAL-INAVI
:Setting the Connected NAVI Model
DVB-T(DMB) ELT_DVBT20
:Setting the Connected DVB-T Model
DVD ELT_980XU Slim
: Setting the Connected DVD Model
RearCam AVM VIDEO
: Setting the Connected RearCam Model
Reset Execute Reset to default value of Config menu
OSD Config
10. OSD(On Screen Display) Control

GU Electronic
OSD - Option Menu
First Menu Second Menu Third Menu Description
Option
SteeringWheel Btn ON
To use the Streeing button You
must select the “ON" button in
the menu
OFF Do not use features.
RearCam-Type OEM Original Camera
ExtDevice Equipped with external camera
RearCam-Power
ON + 12V continuous supply
AUTO + 12V supply only in Rear
camera mode
OFF + 12V off
RearCam-Det GEAR Detected by CAN
WIRE Detected by Rear-Det Wire
AV Mode ON Use “REAR” video input port as
VIDOE input.
OFF Do not use features.
FrontCam-Type OEM Original Camera
ExtDevice Equipped with external camera
FrontCam-Power
ON + 12V continuous supply
AUTO + 12V supply only in Front
camera mode
OFF + 12V off
FrontCam-Det GEAR Detected by CAN
WIRE Detected by Front-Det Wire
FrontCam-RcvOpt ON After RearCam shows FrontCam
and returns to previous state
OFF Disable feature
10. OSD(On Screen Display) Control

GU Electronic
OSD - Option Menu
First Menu Second Menu Third Menu Description
Option
SteeringWheel Btn
Left Use the Left button on the
right side of the handle
Right Use the 'Voice' button on the
right side of the handle
OFF Disable feature
UI DVB-T (DMB) ON DVB-T device control UI output
function
OFF Disable feature
UI DVD ON DVD device control UI output
function
OFF Disable feature
ScrChg-Call ON
Switch to OEM screen when
bluetooth phone comes in,
return to original when phone
terminated
OFF Disable feature
ScrChg_Climate ON
When there is a change of air
conditioning, it switches to
OEM screen for 2 seconds and
then returns to original state
OFF Disable feature
ScrChg-Audio-Vol ON
When there is a change in
audio volume, it switches to
OEM screen for 2 seconds and
returns to original state
OFF Disable feature
3D-COMB-REAR ON It shows the image quality of
the rear camera screen better.
OFF Disable feature
Reset Execute Option Menu all Reset
10. OSD(On Screen Display) Control