Herman Miller Mora Installation instructions

Parts Included
Additional Products Needed - Sold Seperately
Tools Required
HermanMiller
Mora™System End Panel Installation and
Disassembly for Recycling Instructions.
How to assemble your End Bracket.
Wall Cabinet Bracket
CH646. Surface Wall Attachment Support (2)
Power Driver
Level
CH Series Wall Mounted Cabinet or
CH Series To The Floor Cabinet
Work Surface
Toggle Bolt (4)
#10-12 x 3/4 Pan Head
Tapping Screws(4) #10-12 x 5/8 Pan Head
Tapping Screws(4) #8-32 x 1 Pan Head
Machine Screw(4)
End Panel
Step 1
Phillips Bit
1/2” Drill Bit
1/8” Drill Bit
Safety Glass
. Position top Wall Cabinet Bracket on back of End Panel, flush with top
edge, vertically centered on panel.
. Position other Wall Cabinet Bracket flush with back edge of panel,
centered on horizontal center.
. Mark holes.
. Remove brackets. Drill /” pilot holes /” deep. Be careful not to
drill through panel.
. Re-position brackets onto panel. Secure to panel with  # - /” pan
head tapping screws provided with each bracket.
Pan Head Tapping Screw
Wall Cabinet Bracket
Back Edge
Mark Holes
Mark Holes
Mark Holes
Mark Holes
Wall Cabinet Bracket
Glide
Center line of Panel
Drill Stop Set
HermanMiller for Healthcare Assembly Instructions11BHWC3 rev B

HermanMiller for Healthcare Assembly Instructions21BHWC3 rev B
. Mark holes on wall and underside of surface.
. Remove end panel assembly.
. Drill /” pilot holes using drill stop or tape set at a depth of /” max.
This ensure clearance into the Corian for the tip of the screw.
. Drill /” holes through drywall. Make sure there are no utilities present.
. Insert wall anchors into holes. Orient toggles vertically. Secure to wall.
. Aer surface has been mounted on cabinets, position end panel
assembly under end of surface.
. Use front glide to level end panel to surface.
Toggle Bolt
Correct Incorrect
Step 2
Step 3
End Panel Assembly
Surface
Glide
Mark Holes
Mark Holes

Disassembly and Recycling:
Materials Identication and Segregation:
Where possible, plastic components are marked with ASTM recycling
codes. Use these codes to identify material type for recycling. Non marked
components should be treated as mixed plastic. Ferrous metals can be
identied using a small magnet for recycling. Non-ferrous metals should be
separated and recycled separately.
To disassemble product, reverse the above installation steps.
Machine Screw
Tapping Screw
. Reposition end panel assembly under surface. Check to make sure that it
is still level.
. Secure end panel to wall with pan head machine screws provided with
toggle bolt.
. Secure end panel to surface with  # - /” pan head tapping screws
provided with each bracket.
Step 4
HermanMiller for Healthcare Assembly Instructions31BHWC3 rev B