HiB Arcane Curve 50 Black 79500100 User manual

Fitting Instructions
Thank you for purchasing this HiB product.
Please read through these instructions carefully and refer back to
them during installation to ensure that your product is fitted safely
and that it retains its high quality finish.
ARCANE
Arcane Curve 50 Black: Art No 79500100
Arcane Curve 50 Brushed Brass: Art No 79500200
Arcane Curve 60 Black: Art No 79500300
Arcane Curve 60 Brushed Brass: Art No 79500400
Arcane Curve 120 Black: Art No 79500500
Arcane Curve 120 Brushed Brass: Art No 79500600
Arcane Pill 50 Black: Art No 79500700
Arcane Pill 50 Brushed Brass: Art No 79500800
Arcane Round 60 Black: Art No 79500900
Arcane Round 60 Brushed Brass: Art No 79501000
Arcane Round 80 Black: Art No 79501100
Arcane Round 80 Brushed Brass: Art No 79501200
FI#01 039 R221118 Ver No. 1.0 Mar 2023
Arcane Curve
Arcane Pill
Arcane Round

2
Electrical Safety Information
Warnings for Safe Use
HiB recommends that all electrical bathroom products must be installed
in accordance with current building and wiring regulations.
If in doubt please contact an electrician.
Before drilling ensure that there are no hidden cables or pipes in the wall.
• This product is intended for Domestic Use only
• Please read the instructions and warnings carefully before installing the product
and ensure this document is kept with the product for future reference to ensure
product longevity and in the interest of safety.
• If you give the product to another person, please give them this manual as well.
• If any modification is made it will invalidate the warranty and may render the
product unsafe.
• This product is IP44 rated and suitable for installation in Zones 2 and Outside Zone
according to the IEEE regulations.
• It is not suitable for use in saunas, steam rooms and shower cubicles.
• Appropriate circuit protection should be available for the product.
• When drilling use appropriate eye protection.
• The use of a Residual Current Device (RCD) is advised for any power tools used
during the installation of this product.
• Take suitable precautions when handling glass.
• Do not use if glass is broken or unsafe.
• Beware of hidden cables or pipes. Take care if drilling on tiled surfaces in case the
drill slips.
• Always switch off the electrical supply to the product at the mains during
installation and maintenance.
• It is recommended that this product is installed by a person who is able to meet
the level of competence required in order to comply with relevant regulations. If
in doubt consult a qualified tradesperson.
• Do not enter IP44 box unless competent and item is isolated from mains.
• Do not use if any electrical wires appear damaged or degraded.
• This product is designed for installation into a brick or masonry block wall, if
mounting onto other substrate ensure appropriate fixing and batons (if required)
are used and the load bearing of the wall is sufficient.
• It is recommended that this product is installed by two people.
• Avoid leaving excessive standing and surface water on the product for prolonged
periods of time.
• Dispose of packaging in accordance to local authority regulations.
• At end of life dispose of item according to local authority regulations.

3
hib.co.uk
Electrical Information
All installations must comply
with guidelines which are
based on a zonal concept
and must be followed to
ensure the safe installation of
electrical appliances in the
bathroom.
These regulations apply to
domestic installations only.
Installations must be made in
accordance with the current
IEE wiring regulations and
relevant building regulations.
This product is IP44 rated and is suitable for installation in zones: 2& Outside Zone
Live
Earth
Neutral
MAINS SUPPLYLUMINAIRE
Live supply can be Red or Brown
Earth supply is Green and Yellow
Neutral supply can be Blue or Black
Live is Brown
Neutral is Blue
Fig 1. - Zonal Diagram
Caution
We recommend that you place this mirror on a so flat surface to ensure no
breakages. We also recommend that you leave corner protectors on until
final fitting.
Do not li this product via the illuminated frame
CAUTION
This product contains a light source of energy efficiency class F

4
A
What’s in the Box?
Tools Required
Figures
Pencil Spirit Level Drill Drill bit Screwdriver
• Arcane Mirror
• Fittings pack
A
A = Mounting Points

5
hib.co.uk
Fig 2. - Mounting points
A
A
A

6
Installation
It is recommended that this product is installed by two people.
1. Position the mirror in a suitable location according to the zonal diagram - Fig.
1, ensuring that the domestic electrical mains supply is within reach of the
cable connection point of the product.
2. Carefully mark the position of the mirror using a so pencil ensuring it is level.
Remove the mirror and mark the mounting points, see Fig. 2. Please ensure
that all marked mounting points accurately match up with the fixing
points on the mirror.
3. Using a suitable drill bit, drill holes in the marked positions to a suitable
depth. If drilling through tile, use a suitable drill bit.
4. Insert wall plugs level with the surface of the wall. If fitting to a tiled surface,
wall plugs should be inserted below the tile surface to avoid cracking. NB.
For plasterboard walls, specialist fixings should be purchased, available
from any DIY or hardware store.
5. Screw supplied fixings into wall plugs.
6. Ensure the domestic electrical mains supply to which the mirror is being
connected is turned off. Connect the domestic mains supply to the terminal
box according to the wiring diagram, see page 3.
7. Hang the mirror in position.
8. Switch the domestic electrical mains supply for the mirror back on.

7
hib.co.uk
Operation
To switch on/off
1. Wave hand past the sensor switch located on the mirror face, see Fig. 3.
2. Heated pad is on when the mirror is illuminated.
To change the colour temperature
1. Hold hand in front of the sensor switch until desired colour is obtained.
2. The colour temperature is then set until changed again.
Fig 3. - Operation

Care
Aftercare
In the unlikely event that this product should fail please contact the retailer
from which the item was purchased.
To preserve the high quality finish of your HiB product, please ensure you
regard the following care and cleaning recommendations:
• Use only a so damp cloth.
• Wipe off all water spillages as soon as possible.
• Do not use any abrasives or solvents.
WEEE compliance
Must not be mixed with
general household waste
©HiB Copyright: No part of this document may be reprinted or duplicated without HiB consent. All sizes and measurements are approximate, but we do try
and make sure they are as accurate as possible. In the interest of continuous product development, HiB reserves the right to alter specifications as necessary.
E & OE.
T: [phone] F: [phone] E: [e-mail] hib.co.uk
Building 3, North London Business Park, Oakleigh Road South, New Southgate, London. N11 1GN