HID ProxPoint Manual

_____________________________________________________________________________________________________
HID Global 15370 Barranca Parkway, Irvine, CA 92618-1905 USA TEL:[phone] ● 800.237.7769 FAX:[phone]
Web page - www.hidglobal.com - ProxPoint Installation Manual 6005-910 Rev C.1 Page 1 of 2
Install Manual – 6005-910 Rev C
ProxPointTM Installation Manual

_____________________________________________________________________________________________________
HID Global 15370 Barranca Parkway, Irvine, CA 92618-1905 USA TEL: [phone] ● 800.237.7769 FAX: [phone]
Web page - www.hidglobal.com - ProxPoint Installation Manual 6005-910 Rev C.1 Page 2 of 2
PARTS LIST (Included) Quantity
- ProxPoint™ Reader with snap-on
cover and 18” cable 1
- #4-24 x 1” self-tapping flathead screw 2
- Installation manual 1
PARTS LIST (Not-Included) Quantity
- Wire splice 9
- DC Power supply 5.1 VDC or 12 VDC 1
Mounting Instructions
•Determine an appropriate mounting location. The reader
may be mounted to any surface, including metal.
•Drill two (2) 5/64-inch (2mm) holes approximately 1 inch
deep for mounting the reader.
•Drill a 5/8-inch (16mm) hole for the cable.
•Remove the snap-on cover from the reader and secure
the reader to the mounting surface.
•Route the cable from the reader and/or power supply to
the host. A linear type power supply is recommended.
Check all electrical codes for proper cable installation.
•Test the operation of the reader. After completion of the
test, replace the snap-on cover.
•For proper regulatory compliance, the drain wire should
be disconnected at the power supply end of the cable.
•Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
•The Reader is intended to be powered from a limited
power source output of a previously certified power
supply.
•In cold climates (-20°F), when operating the Reader from
a 5V power supply, limit the cable distance to 200ft. For
longer cable distances, 12V is required.
Connecting the Reader to the Host
Connect the reader to the host according to the wiring
table below and the host installation guide.
Wiegand Clock & Data Wire Color
+DC +DC Red
Ground Ground Black
--- Card Present Violet
Data0 Data Green
Data1 Clock White
Shield Ground Shield Ground Drain
Green LED Green LED Orange
Red LED Red LED Brown
Beeper Beeper Yellow
Hold Hold Blue
Testing and Operation
•When power is applied to the reader the LED will
flash green three (3) times while the beeper beeps
simultaneously. The LED will then turn red. This
indicates that the microcontroller is operating
properly.
•Present an ID card to the reader. The LED will
momentarily turn green while the beeper beeps
once, indicating that the card was read
successfully.
Important Product Specifications
Power requirements (linear supply)
Operating Voltage Range 5.1 – 16.0 VDC
Peak Current 80 Ma
Average Current 5V or 12V 20 Ma
Maximum cable distance 500 ft (153 m)
To host
Maximum cable distance 200 ft (61 m)
To host @5V
FCC Compliance Statement: This device complies
with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired operation.