Honeywell 6160AP User manual

INSTALLATION
INSTRUCTIONS
K1346-3 9/01
6160AP Keypad
Description:
The 6160AP is a six wire keypad for use with the Destiny 6100 control panel.
Specifications:
Current draw – 8 mA
Source – 4 wire bus
Operating voltage – 9. to 14V DC
Speaker Resistance – 16 ohms
LCD Abbreviations:
AL – Alert
TR – Trouble / Tamper
BP – Bypass
LB – Low Battery
Wiring:
Four Conductor: Observing proper color code, attach the 6160AP to the 4 wire bus using four-wire
stranded cable. For runs up to 0 feet, 24 gauge wire is recommended and for runs over 0 feet use 22
gauge. An 6160AP can be run directly to the control panel or daisy chained to any other 4 wire bus
peripheral in the system.
Speaker:
Two Conductor: Connect the speaker wires, from the panel, to the “SPEAKER” terminals on the 6160AP.
For best results DO NOT use 6 conductor cable to wire the keypads. A low volume hum may result from
the keypad data lines. Run the speaker wires separately. Refer to the owners manual to determine how to
wire multiple speakers in an installation.

Microphone:
The 6160AP keypad includes a built in house microphone for two-way voice. The microphone MUST be
wired using two conductor shielded cable. Refer to the control panel documentation for microphone
specifications.
Backlight:
Key backlighting can be manually adjusted by simultaneously pressing the 4 and the 7 keys. Each
depression steps the light intensity through one of seven levels.
Display speed:
The rate the LCD display changes from one report to the next is adjustable by depressing the and 8 key
simultaneously. Each depression advances the display to the next fastest of four speeds.
Key Combination Button Programming:
Consult the “Keypad Functions: section of the Installation Manual for key combination and button
programming. All zone descriptions and keypad operations are automatically downloaded to the keypad
after a computer download, system restart (power off then on), or after a ten minute supervision cycle.
Note: It takes several minutes to complete a keypad download.
Keypad Address:
There are 16 keypad addresses that can be used for programming key combinations and some display
options. Refer to the control panel installation to determine how many keypad addresses are supported.
To assign a keypad address, press and hold the 1 digit. With the 1 digit depressed, press F2. Each
additional depression will advance the address. Press the status button to return the keypad to the normal
display.