HOOKE ROAD BXG.2029 User manual

Rear Bumper
(1) Contents:
(2) Tools required:
BXG.2029
19mm Wrench;
19mm Socket Wrench;
5mm Socket Wrench;
Adjustable Wrench;

(3) Installation time:
About 1.5 hours, 2-3 people may be needed. Installation time may
differ according to your mechanical skill level.
(PLEASE VERIFY ALL PARTS ARE PRESENT AND READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION!)
To view the electronic version (BXG.2029), please scan the QR code.

(4) Installation instruction:
Step 1:
Remove the original rear bumper.Then ready to install the new
bumper(PART “B”).
Step 2:
Install the PART “F” on both side of the vehicle.
(The driver side as shown below.)

Step 3:
Step 4:
Tighten the PART “B” with the PART “N”,PART “L” & PART “M”.
(Both side is the same.)
Install the bumper(PART
“B”) on the vehicle. The
picture shows on the RIGHT.

Step 5:
Install the PART”H” with PART”J”,PART”K”,PART”L” & PART”M”.
As shown below.

Step 6:
Ready to install the PART”A” on the PART”B”.
Install the PART”E1”
& PART”E2” on the
PART”A”.

Step 7:
After “Step 6”,install the PART”S” & PART”I” with PART”R” .
As shown below.
Attention：
Highly recommend you maintain the BEARINGS with some lubricating oil
about 3 to 6 months to keep it work fine.
Step 8:
Install the PART”P” on the PART”A” with PART”O”.
A
P
O

Try to Lock the tire carrier.

Step 9:
Install the PART”D1” & PART”D2”.As shown below.
Q

Step 10:
After all above Steps,the installation completed.
Attention:
1.The product parts in this instruction may differ slightly from
the actual product contents but generally does not affect the
installation of the product.
2.Please feel free to contact your distributor if you have any
kind of question about your purchase.
Hooke Road to find your parts