HOOKE ROAD FT.20009 User manual

Adaptive Cruise Control Relocation Bracket
(1) Contents:
Qty
Part Name
Size(mm)
Qty
Part Name
Size(mm)
1
Bracket Assembly
3
Nylon Insert Lock Nut
M6
3
Button Head Socket Cap Bolts Screws
M8*30
3
Nylon Insert Lock Nut
M8
3
Button Head Socket Cap Bolts Screws
M6*16
3
Flat Washer
M8*16*1.5
3
Flat Washer
M6*13*1.5
FT.20009

(2) Tools required:
(3) Installation time:
About 2.5 hours, 1-2 people may be needed. Installation time may differ
according to your mechanical skill level.
(PLEASE VERIFY ALL PARTS ARE PRESENT AND READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION!)
To view the electronic version (FT.20009), please scan the QR code.
a. 8mm & 13mm Sockets; F. Snips/Scissors
b. 4mm Allen Wrench; E. Electrical tape or Wire Heat Shield
c. Flat Head Screwdriver;
d. Pliers;
e. Push Pin Tool;

(4) Installation instruction:
Step 1: Begin by unpacking all items and inspecting for missing pieces or
damage. If you have any concerns, please contact the company the product
was purchased from.
Step 2: With the front bumper removed, begin by removing the cover to the
Adaptive Cruise Control (ACC) module. Grab the top of the cover and pull
outward and slightly down, freeing the top two clips. Set off to the side since
this will not be reused.
Hardware Included：(3)M6*15mm
(3)M8*30mm (3)M6 Lock Nut
(3)M8 Lock Nuts (3)M6 Flat Washer
(3)M8 Flat Washers (6)D Spacers

Step 3: Using an 8mm Socket, remove the three bolts holding the module in
place.
Step 4: Pull the module and bracket away from the vehicle slightly to expose
the plug and squeeze down on the clip to release the module.

Step 5: Using a flat head screwdriver, wedge the tool in between the module
and the bracket near each of the tabs and pull the module off the bracket. You
will need to use firm pressure, but they should not be difficult to
separate. Any excessive force will break the tabs. If the brackets are not
moving after constant pressure, move the tool to the other side of the tab.
Step 6: Once the module is removed, using a pair of pliers, squeeze the tab
bushing out from each hole.

Step 7: To assemble the relocation bracket with the module, using the
provided spacers, place them into the tabs of the module. Two spacers
stacked on top of each other per tab (the spacers will only fit into one side of
the tab, do not force them into the opposite side).
Step 8: Please the bottom half of your new ACC bracket on the module and
secure using the M8 provided hardware. Using a #4 allen head and a 13mm
socket, secure module to bracket.

Step 9: With the module secure, attach the top bracket to the bottom bracket
using the remaining M6 hardware. This will use a 10mm socket and a #3 allen
head, however, leave loose enough to allow adjustment.
Step 10: Next, the installation of the sensor bracket involves cutting. Please
scan the QR code below to open the loading guide to complete the
subsequent installation.

Step 11:
The installation is complete. We hope you enjoy a wonderful off-road life
with this quality Hooke Road product!
Attention:
1.The product parts in this instruction may differ slightly from the
actual product contents but generally does not affect the installation
of the product.
2.Please feel free to contact your distributor if you have any kind
of question about your purchase.
Hooke Road to find your parts