HOOKE ROAD BXG.3018-S User manual

Front Bumper
(1) Contents:
Qty
Part Name
Size(mm)
Qty
Part Name
Size(mm)
1
Front Bumper Assembly
4
Flat Washer
M6*1.5*20
2
Hex Bolt
M12*35
8
Flat Washer
M12*2*30
4
Hex Bolt
M6*16
6
Hex Nuts
M12
8
Split Lock Washer
D12
BXG.3018-S

(2) Tools required:
(3) Installation time:
About 1 hour, 2-3 people may be needed. Installation time may differ
according to your mechanical skill level.
(PLEASE VERIFY ALL PARTS ARE PRESENT AND READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION!)
To view the electronic version (BXG.3018-S), please scan the QR code.
19mm Socket Wrench;

(4) Installation instruction:
Step 1: Assemble the Bull Bar and the Front Bumper Body with the Bracket.
Use the Hex Bolt (M6*16), Flat Washer (M6*1.5*20) to install them. The
Bracket is in the middle.
Step 2:
Remove the original front bumper.

Step 3:
Install the bumper on the vehicle.(JL & JK)

Step 4:
Tighten the bumper.(JL & JK are the same installation method)
(1)Install the Split Lock Washer (D12), Flat Washer (M12*2*30), Hex Nuts
(M12) on the red circle bolt holes.
(2)Install the Hex Nuts (M12*35), Split Lock Washer (D12), Flat Washer
(M12*2*30), Hex Nuts (M12) on the yellow circle bolt holes.

Step 5:
Repeat above steps for another side.
Step 6:
Install the D-rings on the bumper.(JL & JK)

Step 7:
Installation completed.
JL
JK

Attention:
1.The product parts in this instruction may differ slightly from
the actual product contents but generally does not affect the
installation of the product.
2.Please feel free to contact your distributor if you have any
kind of question about your purchase.
Hooke Road to find your parts