Hunter Products Motorized D8060 User manual

Cars McQueen Replica
Troubleshooting Guide

Please follow the directions in the attached service guide to check the connections on your ride on. Most times it is a loose plug or switch that causes electric
ride’s to stop working.
Keep in mind the ride will not operate if the power adaptor/charger cable is plugged into the ride, this is a safety feature to ensure a child does not take off while it’s
plugged in and damage it.
Disconnect the charger from the car before trying to operate it.
To rule out a faulty fuse:
1. Under the seat in the battery compartment please disconnect the short cable from the red terminal of the battery.
2. Then disconnect the long cable that comes from the ride on wiring to the fuse
3. Connect this cable directly to the red terminal of the battery.
So what you have left over is the small black fuse and a short cable attached to it that are not connected to the ride. This is bypassing the fuse, try this to see if it is in fact a
faulty fuse.
If you have a ride on that is 18+ months old and after following these directions you cannot get it going we recommend removing the battery and having the battery &
charger tested by a professional.
Batteryworld.com.au offer this service over the counter in your local outlet.

Item#: 6176
Model# D8060
Description: Cars 3 Lightning McQueen
step 1step 2
step 3 step 4
1. Check the forward/reverse switch.
step 5

step 1 step 2 step 3
step 4 step 5 step 6
2.Remove dashboard before checking the power switch and plugs for switches

step 1 step 2 step 3
step 4 step 5
3.Check the pedal switch connection.

step 1 step 2 step 3
step 4 step 5 step 6
4.Check the internal wire and plug is connected, and make sure the
fuse is connected.Check for bent or damaged pins inside plugs.

step 1 step 2 step 3
5. Steps to replace the gearbox
a. Push the button on the rear driving wheel
b. Cut the tape(if in place) and disconnect the motor/battery plugs
c. Remove the gearbox & inspect for damaged cords, pins or plugs.

REAR WHEEL ASSEMBLY
REAR WHEELS SLIDING SIDE TO SIDE
PLEASE ENSURE REAR AXLE SPACER IS INSERTED ON REAR AXLE
BEFORE FITTING REAR WHEEL.
THIS SHOULD BE INSTALLED ON THE RIGHT HAND REAR WHEEL OR
THE NON MOTOR/GEARBOX SIDE

REAR WHEEL ASSEMBLY
Complaint:
Rear wheels will not stay on or they fall off.
Cause of this complaint:
With 1 wheel fitted to the car, when the customer pushes on the 2nd wheel they are pushing the axle rod back out the other side of
the car. Wheels are not clicking into place.
The solution:
Assembler needs to hold the first wheel in place against the car while they push on the 2nd wheel so they both clip in. Refer photo
below.
Full assembly video at website link below.
www.electricrideon.com.au/mcqueenreplica

MOTOR PLUG –PIN TROUBLESHOOT
No. Pin pushed to side.
When plugged together the pin is not connecting with other plug. Yes. Pin is central.