HunterDouglas 5-156 User manual

REV 01 August`11
2
1
20 21
19
18
1
2
17
16
14 15
Type 5-156
Installation Instruction
Duo Roller Blind (Fascia)
Motor Operation
Move the blind downwards out of the bracket.
Lift the motor front plate up and out of the bracket.
Disconnect the motors and controls. Slide a screw
driver between bearing plug and bracket and push
the bearing in the motor direction.
Place the screw driver under the end cap, turn
the screw driver and slide the end cap from the
bracket.


Removal
Slide the end caps onto the brackets.

a
b
click
c
1
2
3 4
5 6 11
7 8
REV 01 August`11
9
10
12
click
13
Place the blind with the bearing onto the upper
bracket hole. Push the blind against the bearing and
lift the blind up...
Fix the brackets with the screws provided.
a recess b wall c ceiling
Installation
Option: Leveller
Place the upper leveller on the bearing side in the
bracket. Make sure that the opening for the Allen
key is pointing downwards. Turn the leveller until it
clicks. Install the upper blind as described before.
Install the lower leveller and roller blind after hori-
zontal adjusting of the upper blind. The integrated
leveller is already installed in the bracket.

bracket. Press the blind with the motor front plate
down.
Snap the cover into the front plate. Install the lower blind
without turning around the axis. Connect the motors
and controls in accordance with separately provided
instructions. Slide the cables through one bracket hole.
To adjust skewing, put the provided Allen key into
the screw of the leveller and turn it left or right to
move the blind up or down. Support lifting of large
heavy blinds with the palm of your hand.


