HunterDouglas 5-216 User manual

2
1
1
2
Open both fasteners of the bracket ring. Turn the
blind in the roll up direction until the front plate gets
out of the bracket ring.
Type 5-216
Push the blind against the bearing and slide it out
of the bracket.
... and slide it towards you.
Installation Instruction
Roller Blind
Motor Operation
Unfasten the locking ring.
Disconnect the motor. Lift the backside of the end
cap...
Removal

1
2
INSTRUCTIO
2
1
a
c
b
click
click
click
Slide the cover cap onto the bracket until it snaps.
The fasteners of the bracket ring must be open.
Fix the bracket with the screws provided
a recess b ceiling c wall
Place the blind with the bearing onto the bracket.
Push the blind against the bearing and lift the blind
up ...
Fix the blind by turning the locking ring against the
bearing.
Slide the end caps onto the brackets. Make sure that
the end caps snap onto the brackets.
Connect the motor and controls in accordance with
separately provided instructions.
... until the motor front plate ¿ts the bracket ring.
Turn the blind (10°) in the rolling off direction and
close both fasteners of the bracket ring. Make sure
that limit switches are accessible.
To adjust skewing, put the provided Allen key into
the screw of the leveller and turn it left or right to
move the blind up and down. Support lifting of large
heavy blinds with the palm of your hand.
Option: Leveller
Installation
Make sure that the opening for the Allen key is
pointing downwards before installing the brackets.
Change the orientation by loosening the 4 screws
(M5 x 8) and turning the leveller 90°. Fix the screws.