Inspur NF5266M6 User manual

V01503L000000000
Rack-Mounted Server
Installation Guide
V1.0
Warnings!
Please keep this document for future reference.
15kg
30kg
50kg
Watch out for the scratches that may be caused by the cabinet, chassis or rails.
Be aware of electric shock when installing servers into the cabinet in use.
●At least 4 people are needed when installing a 4U server or a server of larger form factor.
●DO NOT block the vents on the server during installation, especially the vents on the front
and rear of the server.
●Remove the protective film from the chassis before installing servers into the rack.
●For proper ventilation, leave a minimum space of 15 cm between two servers.
●Always keep the air ducts in place to ensure proper air flow and avoid air turbulence in the
server room.
●Servers can only be deployed in dedicated cabinets with ventilation holes or specialized
cooling cabinets to avoid server failure from overheating as they are high power appliances.
●In case of multiple-server deployment, always load from bottom to top and place the
heavier server on the lower bay.
●DO NOT install devices beyond the cabinet’s load-bearing capacity, power supply capacity
and heat dissipation capacity.
●For easy access of the front and rear ports and cabling, leave a minimum space of 70 mm
between the front side of the server and the inner side of the cabinet’s front door, and 150
mm between the rear side of the server and the inner side of the cabinet’s rear door.

For devices ≥ 15kg, it requires at least 2 people.
For devices ≥ 30kg, it requires at least 3 people.
For devices ≥ 50kg, it requires at least 4 people.

Rack-Mounted Server Installation Guide V1.0
Rail-Kit Contents
Installing Rails
3
Repeat Step 1 and Step 2 to install the other rail.
1
Determine the post holes for the rear bracket. Align the mounting pins on
the rear bracket with the post holes, pull the release latch as indicated by
arrow ①and then insert the mounting pins into the holes until they are
fully engaged with the holes. Release the rear latch.
Front Bracket
Rear Bracket
1U
2
2
Repeat Step 1 to install the front bracket.
1
1U
2
2
Note: The front bracket, rear bracket and the two rails MUST be installed at
the same height.
1
Loosen the captive screws within the mounting ears.
2
Gently slide the server out as indicated by the arrow.
3
Remove the rails following the installation steps.
4
Gently lift up the server to the height
of the rails. Push the server into the
rack. Then tighten the captive screws
within the mounting ears to secure
the server in place.
Removing Rails
2
1