jbc DI Series User manual

DI
1 TOOL CONTROL UNIT
www.jbctools.com

2
DI / 1 TOOL CONTROL UNIT
DESOLDERING PUMP
STANDS
POWER CORD MANUAL
DI-1B / DI-2B / DI-9B
CONTROL UNIT
Connectable tools: T210, T245, PA120, HT420, AP130, DR560 and DS360.
Connectable modules: MS, MV and KN.
INSTALLATION
HEAT MANAGENEMENT
Power Cord Socket USB Connector
to PC
DI
1 TOOL CONTROL UNIT
Work mode: Lift tool from the stand and the
tool tip heats up to the selected temperature.
Sleep mode: When the tool is in the stand, the
temperature reduces (preset sleep temperature
is 180ºC / 360ºF).
Hibernation mode: After longer periods of
inactivity (pre-set to 30 minutes), the power
is cut off and the tool cools down to room
temperature.
Heat management increase tip life which reduces cost of ownership.
JBC stations intelligently manage the tool tip temperature:
ww w.j bcto ol s.co m

3
Main menu
Counters
Tool settings
Exit
1 Reset settings
2 Station settings
3 Tool settings
1 Plugged hours 0
2 Working hours 0
3 Sleep hours 0
1 Fix one temp -----
2 Temp levels set OFF
3 Sleep delay 0 min
4 Counters
5 Program version
4 Hibernation hours 0
5 No tool hours 0
6 Sleep cycles 0
7 Desold cycles 0
4 Sleep temp 220
0
C
5 Hibernation delay 3 0 min
6 Temp adjust O
O
C
Tool DR
Tool DR
Back
Back
0
c
Selected temp. 350
o
C
Power 10%
350
Decrease & move down Increase & move up
Tip temperature
% Instant power supplied to the tool
ORIGINAL PIN: 0105
Station settings
1 Temp unit Celsius
2 Maximum temp 400
0
C
3 Minimum temp 200
0
C
4 Nitrogen mode OFF
5 Help text OFF
6 Beep ON
7 Power limit 130W
8 Change PIN
Back
Access Menu
&
Conrm
Selection
SETTINGS MENU
CONTROL SCREEN

WARRANTY
JBC’s 2 years warranty guarantees this equipment against all manu-
facturing defects, covering the replacement of defective parts and
all necessary labour.
Warranty does not cover product wear due to use or mis-use.
In order for the warranty to be valid, equipment must be returned,
postage paid, to the dealer where it was purchased enclosing this
fully filled in, sheet.
www.jbctools.com
SERIAL Nº
STAMP OF DEALER
DATE OF PURCHASE
0008528-0413
TECHNICAL SPECIFICATIONS
- Temperature selection from 90°C (190°F) to 450°C (840°F) (±5%).
- Output Peak Power: 130W.
- Safety transformer, mains separator and double isolation.
- DI-2B 230V 50/60Hz. Input fuse: 1A. Output: 23,5V.
- DI-1B 120V 50/60Hz. Input fuse: 2A. Output: 23,5V.
- DI-9B 100V 50/60Hz. Input fuse: 2,5A. Output: 23,5V.
- Total weight of unit : 2 kg (4,3 lb).
- Complies with CE standards on electrical safety, electromagnetic compatibility and
ESD protected housing “skin effect”.
- RoHS compliant.
- Equipotential connector and the tool tip are connected to station mains ground supply for ESD protection.
This product should not be
thrown in the garbage.