John Lewis Shelby 3lt floor task User manual

John Lewis Partnership
171 Victoria Street
London SW1E 5NN
johnlewis.com
Made in China Please retain these instructions for future reference.
5 year guarantee
Aftercare and
Troubleshooting
Max. power: 3 x 7.5W GU10 LED bulbs
Voltage: 220–240V, 50Hz
IP rating: 20
Weight: 6..38kg
At John Lewis & Partners we test every light to high quality standards so we are
able to offer you a 5 year guarantee.
Specification
Recycling
Caring for
your product
We recommend cleaning with a soft dry cloth.
Do not use abrasive materials as these will damage the finish.
Replace bulbs from John Lewis or estabished brand of the same type and
compatibility.
This symbol indicates that this product should not be treated as normal
household waste and it should be recycled. John Lewis & Partners do not
operate instore take back, but as members of the Distributor Take Back
scheme have funded the development and upgrade of recycling facilities across
the UK. Please take it to your nearest collection facility or for further details
contact your local council or visit www.recycle-more.co.uk.
Shelby 3lt floor task
USER GUIDE
Please ensure all screws and small pieces are properly tightened to the product.
When changing a bulb, always switch off the mains and allow the bulb to cool
down before handling.
A bulb’s watt rating indicates how much energy it uses. The higher the watt,
the more energy it requires. Lumens is a measure of brightness. The higher
the number of lumens, the brighter the light.

01 02
Description Image Quantity Parts list
Introduction Thank you for purchasing this Shelby Floor lamp.
Please read the instructions carefully before
use to ensure safe and satisfactory operation
of this product.
Warnings This product is Class II.
This lamp is for indoor use only.
The supply cord cannot be replaced. If the cord is damaged, the table lamp should be
destroyed in order to avoid a safety hazard.
3 x 5 watt energy efficient GU10 LEDS
Bulb replaceable
Bulb not included
Recommended
bulb
Product assembly
1
1
A B
B
A
B
C
D
Lamp Body
Carefully unpack the carton, making sure all parts are
included before assembly. Place lamp parts on a flat
surface.
Screw pole ( A ) clockwise into pole ( B ) until tight.
GU10 LED Bulbs Only
2
BC
B
Screw pole ( B ) clockwise into pole ( C ) until tight.
3
CD
Screw pole ( C ) into base ( D ) until tight.
4
F
Then get the remaining slack of the power cord out
carefully from point ( F ).
Insert GU10 LED Bulbs into socket.
Untie the tie securing cable before use.
Note: Turn lamp on and off with the foot switch.
Please ensure that all screws and small pieces are properly tightened to the product,
especially on the top part of the pole.
The bulb is not included with tis lamp. Please visit your local store to purchase the
bulb prior to assembly.
B
C
D
A
B
C
D
A
F
B
C
C
E
D
D
F