KI Rapture Stack Chair User manual

Turn the chair upside down and place the seat on the corner of a table. Using a Phillips
screwdriver bit, remove the four screws from the seat bottom. Remove the seat shroud
from the chair assembly. Remove two screws, one screw in each of the front two legs.
Turn the chair back over to the upright position.
Pull the front of the arms out of the frame tube. Turn the left and right arms 90°, away
from the seat of the chair. Pull the backrest and arms up away from the frame and seat.
The backrest only needs to be pulled up until the arm can be pulled away from the chair
assembly.
Remove Screws
from Seat Shroud
Remove Screws
from Front Legs

Scrap the old arms or return them to KI. Fetch the new arms and place them in the
backrest cutout arm area.
When both left and right arms are in position, slide the backrest and arms down onto the
frame tubes, towards the seat. When chair back and arms are pushed all the way down
onto frame, turn the arms 90°towards the seat of the chair. The arms will not rotate if the
backrest and arms are not pushed all the way down onto the frame. Push the front end of
the arms in the tubes located in front of the frame.
Arm Placement
Cutout Area

Turn the chair upside down and place the seat on the corner of a table. Place in the
original holes, one screw in each of the two front legs. Put the seat shroud onto the
bottom of the frame. Align the four seat shroud screw holes with the threaded holes on
the poly seat. Replace the four screws that hold the seat shroud and seat to the frame.
You will need a Phillips screwdriver bit to assist you in putting in the six screws.
Replace Screws
in Legs
Replace Four
Screws to Hold
Seat Shroud to the
Frame