KI Jubilee Lounge Seating Guide

Repair & Replacement Instructions
Jubilee™ Lounge Seating
October 2021
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Seat Cushion Replacement
1. Place chair or love seat upside down
onto a soft, protective surface
(Figure 1).
2. To expose the seat screws, partially
remove the fabric veil with either a
staple puller, or cut it all away by
using a utility knife. Use a staple
puller if the veil will be stapled back
on after seat cushion replacement,
or use a utility knife if the veil will be
removed and discarded (Figure 1).
3. Using the appropriate socket size,
remove the four (or eight for love
seat) seat cushion hex screws and
washers (Figure 1).
4. Next, rotate the chair back onto its
legs and the seat cushion can be
lifted away from the chair (Figure 2).
5. To install the new cushion, set it
down onto the chair with the screw
holes facing the chair frame. Then,
rotate the chair back upside down
and soft protective surface (Figure 2).
6. Align the chair and cushion screw
holes and re-install the hex screws
and washers previously removed in
Figure 1.
7. If the fabric veil is to be re-installed,
stretch the fabric and use a staple
gun to do so.

1330 Bellevue Street • P.O. Box 8100 • Green Bay, WI 54308-8100 • Tel [phone] • www.ki.com
© 2021 Krueger International, Inc. All Rights Reserved • Code KI-RR-000033/KI/PDF/1021
Jubilee™ Lounge Seating
Repair & Replacement Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Leg Replacement
1. Place chair upside down onto a
soft, protective surface (Figure 1).
2. Using a Phillips head screw
driver, remove the two screws
holding the leg to the chair
(Figure 1).
3. Once screws are removed, leg
should lift right off (Figure 1).
4. To attach new leg, make sure it is
facing the appropriate direction
and that screw holes are aligned.
Then, install screws removed
from step one. Do not over
tighten (Figure 1).
Threaded Glide Replacement
(wood leg only)
1. Place chair upside down onto a
soft, protective surface.
2. Grip glide with hand and turn
counter clockwise to loosen.
Once loose, un-thread the glide
from the leg (Figure 2).
3. Once glide its removed, thread in
the new replacement glide into
the threaded hole clockwise until
it is tight (Figure 2).