KI Likha Casegoods User manual

Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Adjustable-Height Bridges &
Returns Assembly
Tools Required
• 2” L-brackets
• 5/8” screws
1. Install two L-brackets flush with
the front edge on the unit the
adjustable-height bridge or return
is adjoining to as illustrated. Secure
the L-brackets to the adjoining panel
using two 5/8” screws per bracket
(Figure 1).
2. Position the adjustable-height
bridge or return flush against
the adjustable-height unit with
L-brackets. Attach the properly
positioned bridge or return to the
adjustable-height unit using two 5/8”
screws per bracket (Figure 2).
3. Repeat steps 1 & 2 for the opposite
side of the adjustable-height bridge
unit.
Assembly Instructions
Likha Casegoods
Adjustable-Height Bridges & Returns
September 2022
Figure
1
L
-bracket
L
-bracket
adjoining
panel
5/”
8
screws
5/”
8
screws
adjustable-height unit
(desk shown)
Figure 2
adjustable-height
unit
(desk shown)
adjustable-height
bridge or return
L-bracket

Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
1330 Bellevue Street • P.O. Box 8100 • Green Bay, WI 54308-8100 • Tel [phone] • www.ki.com
© 2022 Krueger International, Inc. All Rights Reserved • Code KI-AI-000107/KI/PDF/0922
Likha Casegoods - Adjustable-Height Bridges & Returns
Assembly Instructions
Control Switch Installation
Parts List
• #8 x 3/4” Phillips pan head screws
(qty 3)
• #6-32 x 7/8” Phillips flat head zinc
screws (qty 2)
• Switch bracket
• Control switch
1. Position the switch bracket plate
under the front, user side of the
worksurface, with the switch bracket
mounting tab against the pedestal
and straight, making sure the switch
bracket is no higher than the top
of the pedestal, and positioned to
be flush with the front edge of the
pedestal drawer face (Figure 3).
2. Using the correctly positioned switch
bracket as a template, mark the
three mounting tab hole locations to
the side of the pedestal, then move
the switch bracket away. Using a
cordless power drill and a 1/32” drill
bit, carefully bore three holes at the
center of the marked locations on the
pedestal side (Figure 3).
3. Align the mounting holes of the
switch bracket mounting tab with the
pre-drilled holes on the side of the
pedestal and secure using three
#8 x 3/4” Phillips pan head screws.
Take care not to over tighten
(Figure 3).
4. Align the mounting holes of the
control switch with the mounting
holes on the switch bracket plate,
Secure switch to the plate using two
#6-32 x 7/8” Phillips flat head zinc
screws (Figure 4).
5. Route the control switch cable
through the kneespace grommet and
plug into the control box under the
kneespace sun top.
Figure 3
switch
bracket
plate
8 x /”
3
4
Phillips pan head
screws switch bracket
mounting
tab
pedestal
drawer
pedestal
(side)
worksurface
Figure 4
control
switch
#6-32 x /”
7
8
Phillips at head
screws
switch
bracket
plate