KI Trek User manual

Assembleunitsasdescribedhereinonly. Todootherwisemayresultininstability. Allscrews,nutsandboltsmustbecheckedperiodically
afterassembly. Failure to assemble properly, or to secure parts may result in assembly failure and injury. Illustrationsand
specificationsarebasedoncurrentproductinformationatthetimeofthisprinting.
standard
base
#14 x 1"
screw
#14 x 1"
screw
leveling
glide
standard
base
table top
Tools Required:
• Phillips Screwdriver
Hardware Included:
• (8) #14 x 1" Wood Screws
• (4) Glides
Note: The instructions below
illustrate the assembly of both the
lightweight folding base (Figure 1)
and the short-fold base (Figure 2).
The item that is required to make the
base a short-fold base is the
short-fold adapter plate (Figure 2).
It is only on one base of each pair.
The adapter plate allows the folded
leg to be clamped shut while
overlapping the opposite leg.
1. Place the table top upside down onto
a soft protective surface.
2. Locate the four pre-drilled holes at
each end of the table. Align the holes
of each base with the pre-drilled holes
in the table. The folded legs of the
bases must be positioned toward the
center of the table. If installation
requires a short-fold base (Figure 2),
the short-fold leg must be positioned
over the standard leg.
3. Secure the bases to the table with four
#14 x 1" wood screws provided.
4. Screw two leveling glides into the
threads at the bottom of each leg.
AssemblyInstructions
Trek™& DataLink®Multipurpose Folding Table
February, 2002
short-fold
base
#14 x 1"
screw
leveling
glide
short-fold
adapter plate
standard
base
table top
Figure 2
Figure 1
KI
1330 Bellevue Street
P.O. Box 8100
Green Bay, Wisconsin 54308-8100
TEL [phone]
FAX [phone]

© KI 2002 Litho in USA Code KI-61265/KP202
1. To unfold: place table top
upside down onto a soft
protective surface.
2. Unsnap table leg from leg holder.
Lift leg to a 90° angle making sure
the base locks securely into place.
3. Repeat step 2 for other leg.
4. To fold: place table top upside down
onto a soft protective surface.
5. While depressing either one or both
of the green release levers on either
side of the leg base, push the leg
down toward the center of the table.
Snap the leg into the plastic leg holder.
6. Repeat step 5 for other leg.
7. If all four glides do not come in
contact with the floor, adjust
appropriate glide(s) in or out to
stabilize table.
8. While in the folded position
the spacing bumpers provide
protection for the top surface of
an adjacent table when tables are
leaned against each other.
Caution: The spacing bumpers
should not be used to stack tables flat
on the floor. Tables are unstable when
stacked in this manner and could
result in personal injury and/or
product damage.
OperationInstructions
Trek™& DataLink®Multipurpose Folding Table
spacing
bumpers
leg
holder
leg
holder
release
lever