Kimball National 2126815 User manual

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 8 .482.1717.
Similarly, to ensure continued enjoyment and use of your product, proper product adjustment, annually and periodically
as needed is the responsibility of the customer.
FigureA
Assembly Instrucon
RecommendTools
• Hex Head screwdriver
PackageContentsQty.
• Table Assembly 1
• Legs 2
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 2126815
Rev B
Printed in U.S.A
© 2 17 Kimball International, Inc.
TrainingTable
LegAttachment
&CableAdjustment
1
Align the table leg so
that the legs are
angled inwards on the approach side of
the table, opposite the release handle.
Place the table leg on the base rail,
align the legs mounng plate holes
with the base rails nuts.
Install and
ghten the 4 screws per leg
into the
nuts (Figure B).
NOTE: Angling the legs al
lows proper
nesng of the tables.
2
Place the work surface upside down
on a smooth, clean surface. Remove
the 4 screws in the 4 nuts per side,
that are located in the base rail
grooves (Figure A).

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 8 .482.1717.
Similarly, to ensure continued enjoyment and use of your product, proper product adjustment, annually and periodically
as needed is the responsibility of the customer.
Assembly Instrucon
RecommendTools
• Hex Head screwdriver
PackageContentsQty.
• Table Assembly 1
• Legs 2
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 2126815
Rev B
Printed in U.S.A
© 2 17 Kimball International, Inc.
TrainingTable
LegAttachment
&CableAdjustment
3
Each table should be examined on an annual basis to make sure the engage
ment of the latches is adequate. The latch should engage the center rail a
minimum of 3 millimeters. (Figure D)
4
Cable tension can be adjusted as
needed. Locate the Cable adjustment
nut on the back of the Release handle.
Turn Nut clockwise to ghten the
tension on the Cable. Turn Nut counter
clockwise to loosen the tension on the
cable (Figure C).
Figure D