Kimball Footprint Radius Profile User manual

Assembly Instructions
Footprint® Page 1 of 2
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Service.
Part No. 2066785 Revision B-08
Drawer Slide Replacement for Radius Profile Box/Box/File Pedestals
Tools Required
IPhillips screwdriver
ISquare
ITape Measure
Description
These instructions provide the basic information replacing
drawer slides on radius profile box/box/file pedestals.
Installation
1. Open drawer and depress latch on drawer slides to
disconnect existing drawer and case members. Remove
screws to detach slide components from drawer and
cabinet.
2. Using new replacement slides, determine right hand from
left hand case member by locating the stamped “L” or “R”
on the slide. Place square on the front edge of cabinet and
scribe a horizontal line on inside surface of each cabinet
end panel in location shown in Figure A.
Note: Box drawers on 30"D pedestals (prior to 2/05/98) will
require 20" file drawer slides located 1⁄8" back from the front
edge of end panels.
3. Position case member back from front edge of end panel
as shown in Figure A and attach with 5⁄8" long screws
(minimum of 4 per 14" or 20" box slide, 4 per 14" or 20"
file slide, or 5 per 26" file slide.)
Figure A
Cabinet Depth
(nominal) “A” “B”
16" 313⁄32"9
1⁄2"
22" 313⁄32"9
1⁄2"
30" 313⁄32"9
1⁄2"
30" (prior to 2/05/98) 23⁄4"8
27⁄32"
Case
Member
1
⁄ 16 "
(BoxDrawerSlide)
19
13
⁄ 16 "
1
⁄ 8 "
(File DrawerSlide)
SIDE VIEW
Cabinet Depth

Assembly Instructions
Footprint® Page 2 of 2
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Service.
Part No. 2066785 Revision B-08
Drawer Slide Replacement, continued
4. Position drawer members (non-handed) against back side
of drawer front and at locations shown in Figure B. Attach
drawer members to drawer sides using 7⁄16" long screws
(minimum of 5 per 14" or 20" box slide, 6 per 14" or 20"
file slide, or 7 per 26" file slide).
5. Pull case members all the way out. Insert drawer by fitting
drawer members under the case member hooks and
snapping down over the front lock.
6. Re-adjust drawer front if necessary by loosening the screws
on the back side of the drawer front.
Figure B
Cabinet Depth
(nominal) “C”
16" 35⁄32"
22" 35⁄32"
30" 35⁄32"
30" (prior to 2/05/98) 37⁄8"
Drawer
Member
ìC ”
51⁄16"
BoxDrawer
Cabinet Depth
BoxDrawer
File Drawer
SIDE VIEW
Printed in U.S.A. © 2008 Kimball International, Inc. T 800.482.1818 F 812.482.8300