Kimball Kore User manual

Kore®
1
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
Part 3139074,
Assembly Instructions
1. Assemble cart following the Assembly Instructions.
2. Unpack cabinet removing hardware and adjustable
shelves.
3. etermine if the cabinet should be mounted on the left
or right then remove the crossrail from that side of the cart
assembly and replace with crossrail included with cabinet
that includes mounting holes. Slide crossrails over the in-
stalled U Brackets with the mounting holes facing outward.
Image shown is a right mounted cabinet. Figure A
Note: Tap the top of the crossrail with the rubber mallet to
seat the U brackets if needed.
4. Place cart on its back on a clean soft surface. Install the
mounting plate on the bottom of the cart frame using sup-
plied M6 machine screws with 4MM hex bit as shown in Fig-
ure B.
5. Align shoulder screws on the side of the cabinet with the
keyhole slots in the crossrail. The back of the cabinet should
be 1/8” off the ground to achieve alignment. Using a card-
board sheet as a spacer makes this task easier. Push the
cabinet and cart together to remove any gap between the
two and then slid the cabinet downward until the bottom of
the cabinet comes in contact with the mounting plate.
Note: if screws do not slide easily into keyhole slots the
height of the screws can be adjusted by turning them 1/4”
turn counterclockwise.
Mobile Workstation - Cabinet attachment
Tools Required
• 4mm hex bit
• #2 Phillips bit
•
Installation
• 4 - M6 X 12mm Cap Screw
• 9 - #8 X 5/8” Phillips Wood screw
• 8 - #8 x 3/4” Phillips Wood screw
Figure B
Crossrail
Surface
Brackets
Figure A
Shoulder
screws
Wood
screws
Figure C
Mounting
Plate
Hardware
• rill or impact driver
• Tape Measure
• Non Maring Rubber Mallet
• 1 - Mounting Bracket
• 1 - Crossrail with key-
holes

Kore®
2
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
Part 3139074,
Assembly Instructions
6. If the cabinet has doors, flush doors with front of cart,
adjust door hinges to achieve 1/16” margin between frame
and door. Units without doors should be inset 1/8” from front
of cart as seen on Figure . Ensure there is no gap be-
tween cart and frame along the back. Secure the cabinet to
the mounting plate using supplied #8 – 5/8” screws.
7. Use holes on bottom plate to locate caster mounting
plate the use #8-3/4” wood screws, to attach to bottom of
cabinet. See Figure E.
8. Install any remaining cabinets or end panels on the
opposite side of the cart if needed. Upright cabinet and cart
assembly then Install adjustable shelves using supplied
pins. Figure F
9. Recommend to have two people raise the unit to the
upright position.
Installation (Continued)
Figure F
Cabinet with doors
Figure
1/16"
1/8"
Cabinet without doors
Figure E