Kimball EVERYSPACE User manual

EVERYSPACE™
1
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent. If you have
any questions concerning these instructions, please call Kimball Customer Care.
Part 3545887, Revision -
Assembly Instructions
Data Beam Connectors
Tools Required
• Box Cutter/Utility Knife
• Drill and hand screwdriver w/#2 Phillips head bit drive
• M4 & M5 Allen hex key
Hardware Required (included)
1 - Data Beam Short/Tall Connector Posts (L,X,T,V,Y)
1 - T-Leg (short/tall)
1 - End Trim
1– Extrusion Assembly (48,60,72)
2 - Data Covers
2 - Pan Head Philips 10-32 X 2”
2 - Flat Washer 10-32
2 - Connector Bolt 1/4-20 X 30
2 - Connector Nuts 1/4-20 X 17
2 - Attachment Plates
6 - Button Head Screws M8-1.25 X 14mm
Installation
1. Using a knife open boxes removing all components/
hardware carefully and place aside. See components in Fig-
ure A and hardware required.
2. Align end trim weld studs with holes on t-legs as shown in
Figure B. Attach using screwdriver ONLY w/#2 Phillips
bit and screws/flat washers. Push button head screws up
through holes of weld plate and thread into attachment plate
loosely. Note: thread loosely so attachment plate will
slide easily into extrusion t-slot, see Figure C Step 3.
3. Slide extrusion over t-leg and connector post (X,T,L,V,Y),
using attachment plates as guides. Plates will slide into t-
slots on bottom of extrusion. Tighten M8 button head
screws with M5 Allen hex key on all legs. Thread remain-
ing button head screws into attachment plates last threaded
hole, pressing against bottom of extrusion. See Figure C.
Figure A
Figure B
Figure C
Attachment
plate
Flat Washer
Pan Head Screw
End Trim
Data Cover
End Trim
Extrusion
Assembly Attachment
Plate
Attachment
Plate
T-Slot
Threaded holes
T-Leg

EVERYSPACE™
2
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent. If you have
any questions concerning these instructions, please call Kimball Customer Care.
Part 3545887, Revision -
Assembly Instructions
4. Refer to Xsede Receptacle AI for pushing in power/USB
receptacles.
5. Run power infeed and jumpers to data blocks. Refer to
jumper to block AI for attachment. Use J-hooks mounted
to extrusion for cable management.
6. Align holes in data covers with holes on t-legs/connector
posts. Using M4 Allen hex key, tighten bolts into connector
nuts. See Figure D.
7. Repeat steps to attach remaining data beams to other posts.
Figure D
Connector
Nuts
Connector
Bolts