Kohler 77981T-4 User manual

1312425-2A-A 1
BEFORE YOU BEGIN
All information is based on the latest product information available at the time of publication. Kohler Co. reserves
the right to make changes in product characteristics, packaging, or availability at any time without notice.
Please leave these instructions for the consumer. They contain important information.
NOTES:
1. Flush the water supply pipes thoroughly to remove debris.
2. Inspect the supply tubing for damage. Replace as necessary.
3. Observe local plumbing codes.
4. For 77981T-4, match with wall-mount dual handle lavatory faucet valve 28139T-NA.
5. For 77981T-8/9, match with wall-mount dual handle lavatory faucet valve 24896T-NA.
6. Install the valve 28139T-NA or 24896T-NA before installing these handles.
1312425-2A-A 4
INSTALLATION INSTRUCTIONS
77981T-4 Wall-Mount Lavatory Handle-Lever
77981T-8 Wall-Mount Lavatory Handle-Oyl
77981T-9 Wall-Mount Lavatory Handle-Industrial
COMPONENTSCOMPONENTS
SERVICE PARTS
**Color code must be specified when ordering.
ROUGH-IN DIMENSIONS
HANDLE OPERATION
77981T-8
Ø61
M28×1
54
38
77981T-4
58
Ø27
Ø60
M28×1
41
57
77981T-4 Wall-Mount Lavatory Handle-Lever
77981T-8 Wall-Mount Lavatory Handle-Oyl
77981T-9 Wall-Mount Lavatory Handle-Industrial
For 77981T-4, turn on the left handle counter-clockwise for hot water, turn on the right handle clockwise for cold
water.
For 77981T-8/9, turn on the left handle clockwise for hot water, turn on the right handle counter-clockwise for
cold water.
77981T-8:3028332
3028291
77981T-4:1043069
77981T-4:1304914**
77981T-4:1304913**
77981T-9:1304916**
77981T-9:1304915**
77981T-9:1043069
77981T-8:1304923**
77981T-8:1304922**
77981T-8:3016159

1312425-2A-A 2 1312425-2A-A 3
INSTALLATION
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could
adversely affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
77981T-9
Ø70
Ø60
M28×1
44.5
61
2
4
3
As figure shown, remove and discard the protectors(1) after completing the finished wall. Turn off the valves.
For 77981T-4 & 77981T-9
Put the washers(2) into the groove of the handle kits(3, 4).
Screw the handle kits(3 or 4) to the sleeves. NOTE: The handle kit with “H” should be installed on the left.
For 77981T-8
Screw the handle kits(6) to the sleeves with handle wrench(5).
Uninstall the handle wrench. Remove the O-ring(7), separate it into two parts as shown. NOTE: The handle kit
with “H” should be installed on the left.
1
6
57
77981T-4 77981T-8 77981T-9
The figures show the correct position of the handles in the closed position.