Kohler TEND K-20713T-ET User manual

TEND
INSTALLATION INSTRUCTIONS
VITREOUS CHINA URINAL
K-20713T-ET
A. HOW TO USE THESE INSTRUCTIONS
Please read these instructions carefully to familiarize
yourself with the required tools, materials, and installation
sequences. Follow the sections that pertain to your
particular installation. This will help you avoid costly
mistakes. In addition to proper installation, read all
operating and safety instructions.
All information in these instructions is based upon the
latest product information available at the time of
publication. Kohler China reserves the right to make
changes in product characteristics, packaging, or
availability at any time without notice.
These instructions contain important care, cleaning, and
warranty information - please leave instructions for the
consumer.
Fixture dimensions are nominal and confirm to tolerances
established by ASME Standard (A112.19.2-2013).
The product complies with GB 6952-2015.
·
·
·
A.
·
·
·-
B. NOTES
·
·
·
·
Observe all local plumbing and building codes.
Shut off the water supply.
Carefully inspect the new fixture for any sign of damage.
Be very careful while shandling vitreous china products.
B.
·
·
·
·
C. REQUIRED TOOLS AND MATERIALS
·
·
·
·
·
·
·
·
Drill
Open end/adjustable wrenches
Tape measure
Thread sealant tape
Basin Wrench
Screwdriver
Sealant
Recommend the no less than 9mm stainless steel twist
pipe as inlet.
C.
·
·
·
·
·
·
·
·
/
9mm
-1-
,2019
Copyright Kohler China Ltd., 2019
BEFORE YOU BEGINBEFORE YOU BEGIN
1389226-T01-A
·
·
ASME (A112.19.2-
2013)
GB 6952-2015
·
·
蒂特

Fig.1
1
ROUGHING-IN
Unit:mm
Reference Value
Kohler reserves the right to change marked dimensions without prior notice.
Notice: a. The dimensions above are just for reference.
b. The layout dimensions of water and outlet see
installation step C(Install the hook).
c. * Recommended dimensions for installation only,
please adjust according to actual situation.
inlet
a.
b. C( )
c. *
-2-
1389226-T01-A
121.1*
201.4
610*
107.1
501.7*
330.1
51
95*
270.1
549.9
376.7*

-3-
Fig.2
2
INSTALLATION
A.
(2)
2
NOTE:
A. INSTALL OUTLET CONNECTION
(See Fig.2)
Ascertain the position for outlet connection according to
rough-in dimensions.
Connect the outlet connection with the trap way. Insert the
gasket into the trap way as shown. Apply sealant on outlet
pipe, connect the outlet connection with outlet pipe.
Fig.2 may be different for different outlet connections.
1389226-T01-A
30*
2~10 mm
100

B.
3
Fig.3
3
B. INSTALL HOOK
(See Fig.3)
Drill mounting holes on the wall and install hook. Fix hook
on the wall by tightening screws.
Fig.4
4
C.INSTALL TOP SPUD AND INLET PIPE
Install top spud, gasket and nut at top of the urinal. Install
sprayer, gasket and nut onto the urinal as shown. Connect
the hose to top spud and sprayer.
-4-
1389226-T01-A
2.3.4.5.
1.
*+29
*
C. 安装进水管
在小便器顶部安装进水螺管，垫圈和螺母。如图所示，将喷嘴，
垫圈和螺母安装到小便器上。将软管连接到顶部螺管和喷嘴。

Fig.5
5
D.
5
(
)
D. INSTALL URINAL
(See Fig.5)
Position the installing hole on the back of the urinal with the
hook. Level the outlet connection which is installed together
with the strainer and the gasket on the trap way. Then insert
the outlet connection into the gasket.(while the outlet
connection is inserted, the trap way can be crutched by hard
exterded via the gap in the bottom of the urinal to install it
decently.) Then fix the urinal on the hook.
-5-
E.
E. INSTALL BEEHIVE STRAINER
Ascertain the position for beehive strainer as shown. Secure
the beehive strainer by tightening screw.
Fig.6
6
1389226-T01-A

-6-
1. Urinal is designed for use with portable water. Avoid water
that includes a lot of contaminants or with acid/alkali water
and impure water.
2. If you live in a hard water area, ensure that the holes in the
toilet rim are kept clean to ensure proper bowl flushing,
Toilet bowl cleaners should be used at least once a week.
Use a long-handled brush to clean the rim holes, and to
clean as far into the trap as possible to prevent mineral
deposits from forming.
3. Most toilet bowl cleaners are not harmful to the surface of
the urinal, Please follow the bowl cleaner manufacturer's
instructions carefully.
4. Do not use abrasive cleaners to clean surfaces.
5. Please flush and clean the urinal regularly to avoid pipe
blockage.
1.
2.
3.
4.
5.
CONSUMER RESPONSIBILITIES
WARNING: Risk of product damage.
Do not throw into the urinal what is easy to block it,
such as newspaper, paper pilch.
Do not bump the vitreous china with great force to
prevent it from damaging and leaking.
Do not use the product in the water below 0 C.
o
CAUTION: Please do not use hard materials (like
scouring pad) to clean product surface, especially the
product logo.
0C
o
1389226-T01-A

TEND
SERVICE PARTS PAGE
VITREOUS CHINA URINAL
K-20713T-ET
(-*) (-**)
Color code (-*) or finish (-**) must be specified when ordering.
-7-
1389226-T01-A
蒂特
53016
Nut
1360937
Gasket
1360934
Top Spud
Hook
1360924
Outlet Connection
1360925
O-ring
1360919
Trapway
滤网
螺钉
滤网接头
垫圈
垫片
喷嘴
螺母
垫片
进水螺管
螺母 软管
挂钩
垫圈
出水接头组件
O 形圈
排水管组件