Kongsberg M3 Sonar User manual

Ethernet Cable
Power Supply
M3 Cable
→
INSTALL THE SOFTWARE
a. Insert the USB ash drive into
your computer.
b. Run the Setup le.
c. Apply the default settings
during installation.
d. Click Yes to install the
KML USB Converter when
prompted.
1
SET YOUR IP ADDRESS
a. Open the Control Panel in
Windows.
b. Select Change adapter
settings.
c. Set your computer’s network
IP address to 192.168.1.233.
d. Set the Subnet Mask to
255.255.255.0.
2
INSTALL YOUR SONAR
a. Connect the M3 system units
as shown.
b. Apply power to the Power
Supply.
3
M3SONAR® QUICKSTART
Kongsberg Mesotech Ltd.
Tel: [phone]
To download the M3 Sonar software or manuals, visit:
http://www.km.kongsberg.com/mesotechsoftware
http://www.km.kongsberg.com/mesotechdocumentation

DISCOVER YOUR SONAR
a. Double-click the M3 icon on
your desktop.
b. Click Setup → System
Conguration → Devices →
Sonar Setup.
c. Click the Discover Sonar
Heads button.
d. Select your Sonar Head.
e. Click Use Discovered Head.
f. Click Close.
4
RUN YOUR SONAR
a. Click Setup → Connect.
b. Verify that the sonar view
updates.
c. Verify that no errors appear
in the Output Messages
window.
d. Click on “Active” on the right
side of the status bar.
e. Verify that all items listed
under the M3 Sonar show
green check boxes.
5
POWER OFF THE SONAR
a. Click Setup → Disconnect in
the M3 software.
b. Close the M3 Software.
c. Turn o󰀨 the computer.
d. Disconnect the power cord
leading to the power supply,
or switch o󰀨 the breaker
supplying power to the M3
Sonar.
6
M3SONAR® QUICKSTART
Kongsberg Mesotech Ltd.
Tel: [phone]
To download the M3 Sonar software or manuals, visit:
http://www.km.kongsberg.com/mesotechsoftware
http://www.km.kongsberg.com/mesotechdocumentation