Kwikset 62822/01 User manual

23/8" (60 mm)
23/4" (70 mm)
Backset
Centerline
13/8" (35 mm)
13/4" (44 mm)
21/4" (57 mm)
Face of the doorEdge of the door
Fold
Doble
A
Installation Guide
If drilling a new door, use
the supplied template and
the complete door drilling
instructions.
Parts in the boxRequired tools
Additional tools
(if needed)
Latch Passage Knobs Screws
Strike Privacy
Knobs
Emergency Unlock tool
(privacy locks only)
Not required for all applications
23/8" (60 mm)
or
23/4" (70 mm)
21/8"
54 mm
1"
25 mm
Drilling TemplateTemplate is only needed if a new hole must be drilled in the door.
Hold the latch in front of the door hole, with
the latch face lush against the door edge.
If the latch holes are centered in the door hole,
no adjustment is required. Proceed to step 4.
If the latch holes are NOT centered, adjust
latch. See “Latch Adjustment” (step 3C).
Latch Adjustment (only if needed)
Move the pin to extend the latch.
wood block
not centered
centered
*Passage knobs only: Call
Kwikset to order a service kit
for 21/4" (57 mm) thick doors.
13/8"–13/4"*
35 mm–44 mm*
A
CD
H
F
K
E
J
G
B
A
or
Prepare door and check dimensions
1
Locate latch
2
Instructions continue on reverse
Note: Knobs will not be
installed until step 5.
Adjust the backset of the latch (if needed)
3
A
B
C
62822 / 01
Do not use harsh chemicals or
solvents to clean your lock.
Mechanical lock
Use a damp cloth to wipe away
any excess dirt or debris.
Electronic lock
Use a damp cloth on the lock’s exterior to wipe away
any excess dirt or debris. Use a dry cloth to clean
interior components.

Door edge NOT
chiseled
Door edge chiseled
align
G
Push up on knob while tightening screws
to keep latch horizontal and centered.
tab
A
Align round edges.
Tip: Pull knob
slightly away
from door to see
where screws insert.
Ensure holes are horizontal.
Press latch bolt
to install knob.
Close door and test latch operation. If latch is
loose in the strike, adjust strike tab so it grips
the latch bolt better when the door is closed.
H
C (2x)
Save the bedroom/bathroom emergency
unlock tool (G) for future use.
IMPORTANT: If installing a passage
lock on an entry door, make sure
the knob with the screw holes is
on the interior side of the door.
slant of latch bolt faces door frame
door frame
C (2x)
D
(2x)
wood block
slant of latch bolt faces door frame
door frame
Remove plates
Install drive-in collar
A
B
F / K
E / J
A
A
B C
ED
B
or
Install latch
4
Install knobs
5
Install strike on door frame
6
Privacy locks only
!
If you’re looking for quality home doors & windows, visit our website.