Kwikset SmartCode 9270CNT-514S User manual

Welcome to the Kwikset family!
This guide will get you up and running
with your new SmartCode™ Lock.
If you have any issues, please visit our
support center: kwikset.com
or call us at 1-800-327-5625.

3
Parts in the box ................................................4
Required tools ..................................................5
Installation...........................................................7
Programming guide ......................................19
Table of contents

Installation

17
SmartCode™ at a Glance
Exterior Interior
1. Number Buttons
Used to enter User Codes. Each code must
be 4 to 8 digits in length.
2. Checkmark
Used for programming.
3. SmartKey Cylinder
Rekeyable cylinder retracts and extends the
latch bolt by key from the exterior.
4. Lock Button
Used for programming, clearing User Code
entry errors, lighting up the keypad and
locking the door.
5. Battery Holder
Uses 4 AA Alkaline batteries, 1.5V
6. Programming Button
Used for programming functions.
7. Turnpiece
Lock and unlock from the interior.
8. Battery Cover
Push it upward and outward to replace
the batteries.
2 4
15
6
78
3

20
Programming Notes
Add User Code:
Up to 50 User Codes can be saved. User Codes should be 4 to 8 digits in length.
For security reasons, the first 4 digits of each User Code must be unique. For
example, you are unable to program a User Code 1-2-3-4-5 as well as a User Code
1-2-3-4-6.
Press the lock button before entering your code to light up the keypad at night.
Enable/Disable Programming Code:
Optional: A Programming Code enables you to make programming changes without
needing to access the programming button. This is ideal for landlords to allow
programming from the outside without access to the interior programming button.
One Programming Code can be saved and should be 4 to 8 digits in length.
The Programming Code can not be the same as any User Code and will not
unlock the lock.
To program the lock when the Programming Code is enabled, instead of pressing
the programming button, enter the Programming Code, press the checkmark and
proceed with the remaining steps on page 19. Repeat the programming steps to
disable the Programming Code. Please note once a Programing Code is enabled,
the programming button is disabled and can only be used to factory reset the lock.
Delete All User Codes:
Keypad locking function will be disabled when User Codes are deleted. The lock
can only be operated manually by key during this time.
Enable/Disable Audio:
LED status indicator will still function once audio is disabled. Repeat the
programming steps to enable the audio.