Kwikset 44594/01 User manual

or
3
REMOVE LEVER AND COVER FROM LEVER ASSEMBLY
1
2
B
A
C
1
1
2
2
3
3
PREPARE LATCH AND INSTALL
Pin
If backset of door measured 2-3/4" (70mm), adjust latch as follows: Grasp the spring pin and
move it to the 2-3/4" slot.
Make sure that slant of latch bolt
faces in the direction that the door
closes.
OPTIONS
MEASURE
Keep handy for emergency unlocking.
2-3/8" (60mm)
2-3/4" (70mm)
Switch lever on exterior assembly as follows.
1. Insert wrench into set screw hole and loosen set screw.
2. Remove lever, replace with other lever and retighten set screw.
INSTALL EXTERIOR & INTERIOR ASSEMBLIES
4
Push latch to insert lever.
Snap on cover.
Tighten set screw to secure lever.
Install lever.
3
7
Continued
1
2
4
23
TRASH
1
FOR LEFT HAND DOORS - ONLY
IMPORTANT INSTALLATION INSTRUCTIONS
Required tools
LEVER - PRIVACY & PASSAGE
WITH 6-WAY LATCH
44594 / 01 CP
6
5
Connect assemblies by installing the mounting screws.
Push up on assembly until screws are level, before
fully tightening.
Do not use harsh chemicals or
solvents to clean your lock.
Mechanical lock
Use a damp cloth to wipe away
any excess dirt or debris.
Electronic lock
Use a damp cloth on the lock’s
exterior to wipe away any excess
dirt or debris. Use a dry cloth to
clean interior components.

FACE
• EDGE
or
DOOR DRILLING
1
3
4 5
2-3/8" 60mm
2-3/4" 70mm
2-1/4" (57mm) 1-3/4" (44mm) 1-3/8" (35mm)
2
Select desired backset
6
1"
25mm
1"
(25mm)
1"
25 mm
1"
(25mm)
2-3/8" (60mm)
2-3/4" (70mm)
BACKSET
Using a 2-1/8" (54mm) diameter hole saw, drill from one side until the point of drill
just breaks through, then complete hole from the other side to prevent splintering.
Drill hole 5/8" (16mm) deep.
Chisel out area until face plate sits flush and drill 3/32" (2mm)
diameter pilot holes for screws. Repeat for strike plate.
BACKSET
Centerline
FOLD OVER
•
TEMPLATE
Drill Hole in Door Face
Drill Hole in Door Edge
Mark Hole for Strike Plate Drill Strike Hole
Face and Strike Plate Cutouts
Mark Holes on Door
Privacy & Passage Lever
44594 / 01 CP
38"
(965mm)
C
L
Extend mark across jamb to door stop. Locate center
of strike hole by measuring back from door stop,
1/2 the thickness of door.
1"
25mm
3/32"
(2mm)
Required tools:
Align latch face plate on door edge and draw outline.
Repeat for strike plate on door jamb.
Copyright © 2010 Kwikset Corporation
5
INSTALL STRIKE
Adjust tang as needed.
Rely on premium home doors & windows by Kwikset if you’re looking for quality and efficiency.