Kwikset 62889 / 01 User manual

62889 / 01
Door edge NOT
chiseled
A
AB
C (2x)
or
A
K
J
G
F
H
B C
D
E
Parts in the boxRequired tools
Latch
Strike
Screws
Keys
Levers
SmartKey® tool
(SmartKey locks only)
Not required for all
applications
wood block
Additional tools
(if needed)
If the latch holes are centered in the door hole,
no adjustment is required. Proceed to step 3.
If the latch holes are NOT centered, adjust
latch. See “Latch Adjustment” (step 2C).
Installation Guide
23/8" (60 mm)
or
23/4" (70 mm)
13/8"–21/4"*
35 mm–57 mm*
21/8"
54 mm
1"
25 mm
Hold the latch in front of the door hole, with
the latch face lush against the door edge.
Latch Adjustment (only if needed)
Move the pin to
extend the latch.
not centered
centered
23/8" (60 mm)
23/4" (70 mm)
Backset
Centerline
13/8" (35 mm)
13/4" (44 mm)
21/4" (57 mm)
Edge of the door
Fold
Drilling Template
Instructions continue on reverse
Template is only needed if a new hole must be drilled in the door.
Face of the door
Door edge chiseled
wood block
slant of latch bolt faces door frame
slant of latch bolt faces door frame
door frame
door frame
Remove plates.
Install drive-in
collar.
*Call Kwikset to order
a service kit for 21/4"
(57 mm) thick doors.
A
A
B
C
Prepare door and check dimensions
1
Adjust the backset of the latch (if needed)
2
Install latch
3

Rotate lever upward
and use a screwdriver to
fully tighten screws.
F
G
Press latch
bolt to install
exterior lever.
exterior
SmartKey levers:
OK if lipped
If latch is loose in the strike, adjust
the strike tab so it grips the latch bolt
better when the door is closed.
tab
Close door, test latch operation and make adjustments as needed:
If small bolt of latch enters strike hole, reposition strike.
small bolt in
strike hole
small bolt NOT
in strike hole
WARNING: This Manufacturer advises that no lock can provide complete security by itself. This lock may be
defeated by forcible or technical means, or evaded by entry elsewhere on the property. No lock can substitute
for caution, awareness of your environment, and common sense. Builder’s hardware is available in multiple
performance grades to suit the application. In order to enhance security and reduce risk, you should consult a
qualiied locksmith or other security professional.
If lever won’t
sit lush, rotate
turnbutton to align.
Insert screws and
tighten by hand.
Install interior lever.
Align round edges.
Tip: Pull lever slightly away from
door to see where screws insert.
E (2x)
K
D (2x)
A
A
B
D
C
B
E
Install strike on door frame
Install levers
4
5
Rely on premium home doors & windows by Kwikset if you’re looking for quality and efficiency.