Kwikset 62883-002 User manual

Optional
Square Rose
62883002 Rev 02
Door edge NOT
chiseled
A
AB
C (2x)
or
M*
A
F
K
L
H
J
G
BC
D
EAdapter*
*Adapter only
included with
straight levers
Parts in the boxRequired tools
Latch StrikeScrews Keys
Levers
SmartKey tool
Not required for all
applications
Allen wrench
wood block
Additional tools
(if needed)
If the latch holes are centered in the door hole,
no adjustment is required. Proceed to step 3.
If the latch holes are NOT centered, adjust
latch. See “Latch Adjustment” (step 2C).
Installation Guide
23/8" (60 mm)
or
23/4" (70 mm)
13/8"–21/4"*
35 mm–57 mm*
21/8"
54 mm
1"
25 mm
Hold the latch in front of the door hole, with
the latch face lush against the door edge.
Latch Adjustment (only if needed)
Move the pin to
extend the latch.
not centered
centered
23/8" (60 mm)
23/4" (70 mm)
Backset
Centerline
13/8" (35 mm)
13/4" (44 mm)
21/4" (57 mm)
Edge of the door
Fold
Drilling Template
Instructions continue on reverse
Template is only needed if a new hole must be drilled in the door.
Face of the door
Door edge chiseled
wood block
slant of latch bolt faces door frame
slant of latch bolt faces door frame
door frame
door frame
Remove plates.
Install drive-in
collar.
*Call Kwikset to order
a service kit for 21/4"
(57 mm) thick doors.
A
A
B
C
Prepare door and check dimensions
1
Adjust the backset of the latch (if needed)
2
Install latch
Instale el pestillo
3

Push up on lever base while
tightening screws to keep latch
horizontal and centered.
H
Press latch bolt to
install exterior lever.
exterior
Install adapter* in
exterior door hole.
exterior
OK if lipped
If latch is loose in the strike, adjust
the strike tab so it grips the latch bolt
better when the door is closed.
tab
Close door, test latch operation and make adjustments as needed:
If small bolt of latch enters strike hole, reposition strike.
small bolt in
strike hole
small bolt NOT
in strike hole
WARNING: This Manufacturer advises that no lock can provide complete security by itself. This lock may be
defeated by forcible or technical means, or evaded by entry elsewhere on the property. No lock can substitute
for caution, awareness of your environment, and common sense. Builder’s hardware is available in multiple
performance grades to suit the application. In order to enhance security and reduce risk, you should consult a
qualiied locksmith or other security professional.
If lever base won’t sit lush,
rotate turnbutton to align.
Install interior
lever base. Align round edges.
E
Tip: Pull lever slightly away from
door to see where screws insert.
E (2x)
*Adapter only
included with
straight levers
counter-clockwise
clockwise
Install interior lever and tighten
pre-installed set screw.
M
J
L
L
correct incorrect
unlocked
Loosen the pre-installed set screw to
remove lever. Do not remove set screw.
Find your lever
style in the chart
and determine if
your levers are
oriented correctly:
If oriented incorrectly, remove
both levers and install them on
opposite sides of the door.
F
D (2x)
A
A
B
D
G
F
C
B
Install adapter (if included in the box)
4
Install strike on door frame
Remove interior lever
5
Install levers
6
7
If you’re looking for quality home doors & windows, visit our website.