L.L.Bean ADIRONDACK BISTRO TABLE 30" User manual

ADIRONDACK BISTRO TABLE 30”
Thank you for purchasing this L.L. Bean Home Adirondack Bistro Table.
Assembly of this product requires a Phillips screwdriver. We have found it helpful
to have a second person assist with assembly.
931 0HVP5100317

STEP 1
Read through these instructions thoroughly before
beginning assembly. We have found this to be of
great value when first assembling this product.
STEP 2
Remove all parts and hardware from packing
material. Wooden pieces should be placed on a non-
abrasive surface (like carton or carpet) to prevent
damage to the finish.
STEP 3
Identify all parts using diagram at right
STEP 4
Identify and count hardware using diagram at right.
Assembly of this product requires a Phillips
screwdriver.
STEP 5
Lay the Top (A) on a flat non-abrasive surface with
the cleats facing up as shown to the right.
Insert the (4) nylon sleeves into the holes in the short
and long cleats ensuring they are inserted from the
insides of each cleat as shown to the right.

STEP 6
Align Leg Assembly (B) with Top (A) as shown to
the right, ensuring the holes in the legs line up with
the holes in the cleats on Top (A). Also make sure
the inside legs are positioned to the inside of the
short cleat
STEP 7
Attach outside leg of Leg Assembly (B) to the long
cleat of Top (A) by placing a washer onto a machine
bolt, and inserting through the outside of the cleat
and into the nylon sleeve that was previously
inserted into the hole in the long cleat. The machine
bolt should then be tightened into the nut that has
been pre-installed into the outside leg of Leg
Assembly (B). Repeat this step for the other outside
leg.
STEP 8
Attach inside leg of Leg Assembly (B) to the short
cleat of Top (A) by placing a washer flat against
short cleat so it doesn’t scratch paint, then insert
machine bolt into the nylon sleeve that was
previously inserted into the hole in the short cleat.
The machine bolt should then be tightened into the
nut that has been pre-installed into the inside leg of
Leg Assembly (B). Repeat this step for the other
inside leg.
CARE
Your painted table is finished with an acrylic paint
that is mildew and stain resistant. To clean, wipe
accumulated dirt with a solution of warm soapy
water and a soft cloth; rinse thoroughly with clean
water. Your natural oak table is finished with a clear
wood preservative coating.
Decks, porches and patios are the best locations for
outdoor use. Store in a dry, covered area when not in
use or for off-season storage.
www.llbean.com
Product Support 1 800 341 4341