L.L.Bean MISSION ENTERTAINMENT STAND User manual

STEP 1
Read through these instructions
thoroughly before you begin assembly.
We have found this to be of great value
when first assembling this product.
STEP 2
Remove all parts and hardware from
packing material. Wooden pieces
should be placed on a non-abrasive
surface (like the carton or carpet) to
prevent damage to the finish.
STEP 3
Identify all parts using diagram at right.
STEP 4
Identify and count hardware using diagrams at
right and below.
(2) Door Pulls
(2) 5/8” Pan Screws
STEP 5
Stand the side assembly (A) on edge
and attach bottom assembly (B)
with two 1-1/4” #8 screws. Repeat
to attach other side.
STEP 6
Stand unit upright. Insert hinge pin
into each predrilled hole in front
corner of bottom shelf and drop two
washers over each pin.
STEP 7
Mount magnet catch in predrilled
holes in underside of shelf (C)
using 1/2" #6 Pan screws
provided.
STEP 8
Mount magnet plate to back of each door
using 1/2" #5 Flat screw.
STEP 9
Attach Door pulls by placing pulls through
decorative plates, then through door,
securing with 5/8” pan screws.
STEP 10
Add shelf (C) to cabinet
assembly by aligning both side
assemblies (A) using one 1 1/4"
#8 screw on each side. This
will enable you to pivot the
shelf to install the doors.
DO NOT FULLY TIGHTEN
THE SCREWS.
We found it helpful to use one
door (D) to hold the shelf in
place as shown to right.

STEP 11
Insert one 1" steel hinge pin into
predrilled hole in top edge of each
door. Pivot shelf (C) upward and
position left door so that predrilled
hole in top edge of Door (D) engages
hinge pin in left front corner of shelf
assembly (B) installed in STEP 7.
Align hinge pins in top edge of door
with predrilled hole in underside of
shelf (C). Drop shelf down to trap
door in place.
TIGHTEN ALL SCREWS ON
SHELF (C).
STEP 12
Attach top assembly (E) to side
assemblies (A) by inserting 1 1/4"
#8 screws through counter sunk
holes in side assemblies into pilot
holes in the top assembly supports.
STEP 13
Tap in wood plugs with hammer to
conceal screws.
CARE
Dust as needed with soft cloth. Clean with
damp cloth and mild solution of dish soap.
Polish with soft cloth and polish that contains
no pigment or silicone.
www.llbean.com
Product Support 1 800 341 4341
MISSION ENTERTAINMENT
STAND
Thank you for purchasing our Mission Entertainment Stand. Assembly of this product
requires a Phillips screwdriver and a hammer. We found it helpful to have a second
person assist with a couple of the steps.
7634 KUU4101123